|
Diallyl Phthalate (DAP) Processing Information
|
|
Free Access to 80,000 Datasheets
|
|
English
|
| Density (g/cm³) | 1.88 to 2.00 | | Mold Shrinkage, Flow (in/in) | 0.0019 to 0.0030 | | Melt Mass Flow Rate (g/10 min) | -- | | Drying Temperature (°F) | -- | | Drying Time (hr) | -- | | Suggested Max Moisture (%) | -- | | Suggested Max Regrind (%) | -- | | Injection Pressure (psi) | -- | | Rear Temperature (°F) | -- | | Middle Temperature (°F) | -- | | Front Temperature (°F) | -- | | Nozzle Temperature (°F) | -- | | Processing (Melt) Temp (°F) | -- | | Mold Temperature (°F) | -- |
SI
|
| Density (g/cm³) | 1.88 to 2.00 | | Mold Shrinkage, Flow (cm/cm) | 0.0019 to 0.0030 | | Melt Mass Flow Rate (g/10 min) | -- | | Drying Temperature (°C) | -- | | Drying Time (hr) | -- | | Suggested Max Moisture (%) | -- | | Suggested Max Regrind (%) | -- | | Injection Pressure (MPa) | -- | | Rear Temperature (°C) | -- | | Middle Temperature (°C) | -- | | Front Temperature (°C) | -- | | Nozzle Temperature (°C) | -- | | Processing (Melt) Temp (°C) | -- | | Mold Temperature (°C) | -- |
|
|