| Polybutadiene Rubber (PBR)
Processing Information |
Share This Page
• Free Access to 80,000 Datasheets
|
|
English
|
| Density (g/cm³) | 0.890 to 0.908 | 0.917 to 0.998 | -- | 0.932 to 0.990 | | Mold Shrinkage, Flow (in/in) | -- | -- | -- | -- | | Melt Mass Flow Rate (g/10 min) | -- | -- | -- | 60 to 100 | | Drying Temperature (°F) | -- | -- | -- | -- | | Drying Time (hr) | -- | -- | -- | -- | | Suggested Max Moisture (%) | -- | -- | -- | -- | | Suggested Max Regrind (%) | -- | -- | -- | -- | | Injection Pressure (psi) | -- | -- | -- | -- | | Rear Temperature (°F) | -- | -- | -- | 248 | | Middle Temperature (°F) | -- | -- | -- | 248 | | Front Temperature (°F) | -- | -- | -- | 248 | | Nozzle Temperature (°F) | -- | -- | -- | -- | | Processing (Melt) Temp (°F) | -- | -- | -- | -- | | Mold Temperature (°F) | -- | -- | -- | -- |
SI
|
| Density (g/cm³) | 0.890 to 0.908 | 0.917 to 0.998 | -- | 0.932 to 0.990 | | Mold Shrinkage, Flow (cm/cm) | -- | -- | -- | -- | | Melt Mass Flow Rate (g/10 min) | -- | -- | -- | 60 to 100 | | Drying Temperature (°C) | -- | -- | -- | -- | | Drying Time (hr) | -- | -- | -- | -- | | Suggested Max Moisture (%) | -- | -- | -- | -- | | Suggested Max Regrind (%) | -- | -- | -- | -- | | Injection Pressure (MPa) | -- | -- | -- | -- | | Rear Temperature (°C) | -- | -- | -- | 120 | | Middle Temperature (°C) | -- | -- | -- | 120 | | Front Temperature (°C) | -- | -- | -- | 120 | | Nozzle Temperature (°C) | -- | -- | -- | -- | | Processing (Melt) Temp (°C) | -- | -- | -- | -- | | Mold Temperature (°C) | -- | -- | -- | -- |
|
|