| Polyphenylene Sulfide (PPS)
Processing Information |
|
|
English
|
| Specific Gravity | 1.26 to 1.75 | 1.15 to 1.31 | 1.44 to 1.59 | | Mold Shrinkage, Flow (in/in) | 0.0010 to 0.28 | -- | 0.0045 to 0.0050 | | Melt Mass Flow Rate (g/10 min) | 75 to 5000 | -- | -- | | Drying Temperature (°F) | 274 to 302 | -- | -- | | Drying Time (hr) | 3.9 to 6.1 | -- | -- | | Suggested Max Moisture (%) | 0.015 to 0.20 | -- | -- | | Suggested Max Regrind (%) | 20 | -- | -- | | Injection Pressure (psi) | 12400 to 16400 | -- | -- | | Rear Temperature (°F) | 553 to 630 | -- | -- | | Middle Temperature (°F) | 566 to 630 | -- | -- | | Front Temperature (°F) | 585 to 621 | -- | -- | | Nozzle Temperature (°F) | 594 to 610 | -- | -- | | Processing (Melt) Temp (°F) | 596 to 613 | -- | -- | | Mold Temperature (°F) | 250 to 313 | -- | -- |
SI
|
| Specific Gravity (g/cm³) | 1.26 to 1.75 | 1.15 to 1.31 | 1.44 to 1.59 | | Mold Shrinkage, Flow (cm/cm) | 0.0010 to 0.28 | -- | 0.0045 to 0.0050 | | Melt Mass Flow Rate (g/10 min) | 75 to 5000 | -- | -- | | Drying Temperature (°C) | 134 to 150 | -- | -- | | Drying Time (hr) | 3.9 to 6.1 | -- | -- | | Suggested Max Moisture (%) | 0.015 to 0.20 | -- | -- | | Suggested Max Regrind (%) | 20 | -- | -- | | Injection Pressure (MPa) | 85.8 to 113 | -- | -- | | Rear Temperature (°C) | 289 to 332 | -- | -- | | Middle Temperature (°C) | 297 to 332 | -- | -- | | Front Temperature (°C) | 307 to 327 | -- | -- | | Nozzle Temperature (°C) | 312 to 321 | -- | -- | | Processing (Melt) Temp (°C) | 313 to 323 | -- | -- | | Mold Temperature (°C) | 121 to 156 | -- | -- |
|
|