IDES Prospector Already have an account? Login Here

IDES

Xantar® RX 1045

Polycarbonate

Supplied by Mitsubishi Engineering-Plastics Corp

The technical datasheet with complete property values for Xantar® RX 1045 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Europe
Additive 
  • UV Stabilizer
Features 
  • Low Viscosity
RoHS Compliance 
Appearance 
  • Colors Available
Forms 
  • Pellets
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ISO 1183
Melt Volume-Flow Rate (MVR) (300°C/1.2 kg)
in³/10min
 ISO 1133
Molding Shrinkage - Flow
%
 ISO 294-4
Water Absorption (Saturation, 73°F)
%
 ISO 62
Limiting Viscosity Number
in³/lb
 ISO 1628-4
Mechanical
Nominal Value
Unit
Test Method
Tensile Modulus
psi
 ISO 527-2
Tensile Stress (Yield)
psi
 ISO 527-2
Tensile Strain (Yield)
%
 ISO 527-2
Nominal Tensile Strain at Break
%
 ISO 527-2
Flexural Modulus
psi
 ISO 178
Flexural Strength
psi
 ISO 178
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact Strength (73°F)
ft·lb/in²
 ISO 180/1A
Hardness
Nominal Value
Unit
Test Method
Rockwell Hardness (M-Scale)
 
 ISO 2039-2
Thermal
Nominal Value
Unit
Test Method
Heat Deflection Temperature (264 psi, Unannealed)
°F
 ISO 75-2/A
Vicat Softening Temperature
°F
 ISO 306/B50
CLTE - Flow
in/in/°F
 ISO 11359-2
Additional Information
Ball Pressure Temperature, IEC 60695-10-2: 125°C
Thermal Conductivity of Melt: 0.24 W/(m-K)
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Xantar® RX 1045, Xantar RX 1045, Xantar® , Xantar, XantarRX1045, RX 1045, RX1045, Polycarbonate, PC, Mitsubishi EP, 1045RX
Features
Features may also be described by the following terms: Low Viscosity.
Injection
Nominal Value
Unit
 
Drying Temperature
°F
  
Drying Time
hr
  
Suggested Max Moisture
%
  
Suggested Shot Size
%
  
Rear Temperature
°F
  
Middle Temperature
°F
  
Front Temperature
°F
  
Nozzle Temperature
°F
  
Processing (Melt) Temp
°F
  
Mold Temperature
°F
  
Injection Pressure
psi
  
Injection Rate
 
  
Back Pressure
psi
  
Screw L/D Ratio
 
  
Screw Compression Ratio
 
  
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.