IDES Prospector Already have an account? Login Here

IDES

Salflex 364AL

Thermoplastic Vulcanizate

Supplied by Salflex Polymers Ltd.

The technical datasheet with complete property values for Salflex 364AL is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Features 
  • Fatigue Resistant
  • Good Flexibility
  • Good Tear Strength
  • High Impact Resistance
  • Ozone Resistant
Uses 
  • Automotive Applications
  • Automotive Interior Trim
  • Grommets
  • Liners
  • Overmolding
Forms 
  • Pellets
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ISO 1183/A
Molding Shrinkage
%
 ISO 294-4
Elastomers
Nominal Value
Unit
Test Method
Tensile Stress (100% Strain)
psi
 ISO 37
Tensile Stress (Break)
psi
 ISO 37
Tensile Elongation (Break)
%
 ISO 37
Tear Strength 2
lbf/in
 ISO 34-1
Compression Set (158°F, 22.0 hr)
%
 ISO 815
Hardness
Nominal Value
Unit
Test Method
Shore Hardness (Shore A, 15 sec)
 
 ISO 868
Aging
Nominal Value
Unit
Test Method
Change in Tensile Stress (257°F, 168 hr, in IRM 903 Oil)
%
 ISO 1817
Change in Tensile Strain at Break (257°F, 168 hr, in IRM 903 Oil)
%
 ISO 1817
Change in Volume (257°F, 168 hr, in IRM 903 Oil)
%
 ISO 1817
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Salflex 364AL, Salflex , Salflex364AL, 364 AL, 364AL, Thermoplastic Vulcanizate, TPV, Thermoplastic Elastomer, TPE, ThermoplasticVulcanizate, ThermoplasticElastomer, AL364
Features
Features may also be described by the following terms: High Impact Resistance, Good Flexibility, Flexible, Good Tear Strength.
Uses
Uses may also be described by the following terms: Automotive Applications, Automotive Sector.
Injection
Nominal Value
Unit
 
Drying Temperature
°F
  
Drying Time
hr
  
Rear Temperature
°F
  
Middle Temperature
°F
  
Front Temperature
°F
  
Nozzle Temperature
°F
  
Processing (Melt) Temp
°F
  
Mold Temperature
°F
  
Notes
1Typical properties: these are not to be construed as specifications.
2Method Bb, Angle (Nicked)
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.