IDES Prospector Already have an account? Login Here

IDES

UTTAP SF 600

Polyethersulfone

Supplied by Ovation Polymers Inc.

The technical datasheet with complete property values for UTTAP SF 600 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
Polyether Sulfone Resin - Medium Viscosity, un-reinforced standard grade for easy injection molding.
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Features 
  • Medium Viscosity
Forms 
  • Pellets
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Mechanical
Nominal Value
Unit
Test Method
Tensile Modulus 2 (73°F)
psi
 ASTM D638
Tensile Strength 2 (Yield, 73°F)
psi
 ASTM D638
Tensile Elongation 2 (Break, 73°F)
%
 ASTM D638
Flexural Modulus 3 (73°F, 1.97 in Span)
psi
 ASTM D790
Flexural Strength 3 (Yield, 73°F, 1.97 in Span)
psi
 ASTM D790
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact (73°F)
ft·lb/in
 ASTM D256
Thermal
Nominal Value
Unit
Test Method
Deflection Temperature Under Load (264 psi, Unannealed, 0.126 in)
°F
 ASTM D648
Glass Transition Temperature
°F
 ASTM E1356
Additional Information
DTUL @ 264psi, ASTM D648, Unannealed, 3.2 mm: > 195 mm
The value listed as Glass Transition Temp, ASTM E1356 was tested in accordance with ASTM D3482.
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: UTTAP SF 600, UTTAP , UTTAPSF600, SF 600, SF600, Polyethersulfone, PESU, Polysulfone, PSU, Ovation Polymers, 600SF
Features
Features may also be described by the following terms: Medium Viscosity.
Notes
1Typical properties: these are not to be construed as specifications.
22.0 in/min
30.051 in/min
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.