IDES Prospector Already have an account? Login Here

IDES

GELAST 1180

Thermoplastic Vulcanizate

Supplied by Guang Sung Plastics (GSPL)

The technical datasheet with complete property values for GELAST 1180 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
Features 
  • Crosslinkable
  • High Heat Resistance
  
Uses 
  • Cable Jacketing
  • Hose
  • Plugs
  • Tubing
  
RoHS Compliance 
Forms 
  • Pellets
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Elastomers
Nominal Value
Unit
Test Method
Tensile Set
%
 ASTM D412
Tensile Stress (100% Strain)
psi
 ASTM D412
Tensile Strength (Yield)
psi
 ASTM D412
Tensile Elongation (Break)
%
 ASTM D412
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore A)
 
 ASTM D2240
Thermal
Nominal Value
Unit
Test Method
Brittleness Temperature
°F
 ASTM D746
Additional Information
Tension Srength, ASTM D624: 35 kg/cm
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: GELAST 1180, GELAST , GELAST1180, 1180, Thermoplastic Vulcanizate, TPV, Thermoplastic Elastomer, TPE, Guang Sung, ThermoplasticVulcanizate, ThermoplasticElastomer
Features
Features may also be described by the following terms: High Heat Resistance.
Uses
Uses may also be described by the following terms: Tubing, Tube.
Injection
Nominal Value
Unit
 
Processing (Melt) Temp
°F
  
Screw L/D Ratio
 
  
Screw Compression Ratio
 
  
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.