IDES Prospector Already have an account? Login Here

IDES

GELAST GT501

Styrene Ethylene Butylene Styrene Block Copolymer

Supplied by Guang Sung Plastics (GSPL)

The technical datasheet with complete property values for GELAST GT501 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
Uses 
  • Automotive Interior Trim
  • Handles
  • Household Goods
  • Sporting Goods
  • Toys
  • Water Sports Equipment
RoHS Compliance 
Forms 
  • Pellets
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Mechanical
Nominal Value
Unit
Test Method
Tensile Modulus - 100% Secant
psi
 ASTM D638
Tensile Strength
psi
 ASTM D638
Tensile Elongation (Break)
%
 ASTM D638
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore A, 5 sec)
 
 ASTM D2240
Additional Information
Tension Srength, ASTM D624: 12.2 kg/cm
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: GELAST GT501, GELAST , GELASTGT501, GT 501, GT501, Styrene Ethylene Butylene Styrene Block Copolymer, SEBS, Thermoplastic Elastomer, TPE, Guang Sung, StyreneEthyleneButyleneStyreneBlockCopolymer, ThermoplasticElastomer, 501GT
Uses
Uses may also be described by the following terms: Household Goods, Housewares, Water Sports Equipment, Watersports Equipment, Water Sport Equipment.
Injection
Nominal Value
Unit
 
Processing (Melt) Temp
°F
  
Screw L/D Ratio
 
  
Screw Compression Ratio
 
  
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.