IDES Prospector Already have an account? Login Here

IDES

Regis™ 275107

Polyolefin

Supplied by Noble Polymers

The technical datasheet with complete property values for Regis™ 275107 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
Regis is a TPO (thermoplastic olefin) produced by Noble Polymers based on olefin/elastomer compounding. We have created Regis for use in bumpers and bumper fascias, air dams, exterior panels, material handling, step pads and other applications requiring rigid TPO's. This recyclable product is a tough, high-strength thermoplastic that maintains its properties over a wide temperature range.
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Features 
  • Good Toughness
  • High Strength
  • Recyclable Material
Uses 
  • Automotive Applications
  • Automotive Bumper
  • Automotive Exterior Parts
Forms 
  • Pellets
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Melt Mass-Flow Rate (MFR) (230°C/2.16 kg)
g/10 min
 ASTM D1238
Molding Shrinkage - Flow
in/in
 ASTM D955
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength (Yield)
psi
 ASTM D638
Tensile Elongation (Break)
%
 ASTM D638
Flexural Modulus - Tangent
psi
 ASTM D790
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact
     ASTM D256
-4°F
ft·lb/in
  
73°F
ft·lb/in
  
Gardner Impact
     ASTM D3029
-22°F
in·lb
  
73°F
in·lb
  
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Regis™ 275107, Regis 275107, Regis™ , Regis, Regis275107, 275107, Polyolefin, Unspecified, Polyolefin Unspecified, Polyolefin, Noble Polymers, PolyolefinUnspecified
Features
Features may also be described by the following terms: Good Toughness, Tough, High Strength.
Uses
Uses may also be described by the following terms: Automotive Bumper, Automotive Bumpers, Automotive Applications, Automotive Sector.
Injection
Nominal Value
Unit
 
Rear Temperature
°F
  
Middle Temperature
°F
  
Front Temperature
°F
  
Injection Notes
Water Temperature: 80 to130°F
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.