IDES Prospector Already have an account? Login Here

IDES

PRE-ELEC ESD 4000

Polyolefin

Supplied by PREMIX OY

The technical datasheet with complete property values for PRE-ELEC ESD 4000 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
PRE-ELEC® ESD 4000 is a polyolefin compatible dissipative masterbatch developed for PELD and PE-HD film, sheet, blow and injection moulded products. The active substance is an IDP (inherently dissipative polymer) and it gives a permanent dissipative property also at low humidity. The surface resistance level at 1x109 - 1x1012 ohms can be achieved at 8-20% dosing level (EOS/ESD S11.11-1993, IEC 61340-5-1).

The let down ratio of the masterbatch should be tested prior to its use with the polymer used in order to reach the desired dissipative level.

PRE-ELEC® ESD 4000 can be used in clean room applications. The processing temperature should be less than 220 °C (430 °F) and the material should be pre-dry before processing.
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
  • Europe
  • North America
  • South America
  
Uses 
  • Blow Molding Applications
  • Film
  • Masterbatch
  • Sheet
  
Appearance 
  • Yellow
Forms 
  • Granules
Processing Method 
  • Blow Molding
  • Injection Molding
  
Physical
Nominal Value
Unit
Test Method
Specific Gravity
      
--
 
 ASTM D792
--
g/cm³
 ISO 1183
Electrical
Nominal Value
Unit
Test Method
Surface Resistivity
ohms
 ASTM D257, IEC 60093
Additional Information
Surface Resistivity, EOS/ESD S11.11-1193 / IEC 61340-5-1: 1E9 to 1E12 ohms
Dosing: 8 to 20%
Moisture Content: Max 0.25% when produced
Additive: IDP
Temperature Stability: <220°C
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: PRE-ELEC ESD 4000, PREELEC ESD 4000, PRE-ELEC , PREELEC, PRE:ELEC, PRE/ELEC, PRE+ELEC, PRE_ELEC, PRE ELEC, PREELECESD4000, ESD 4000, ESD4000, Polyolefin, Unspecified, Polyolefin Unspecified, Polyolefin, Premix OY, PolyolefinUnspecified, 4000ESD
Injection
Nominal Value
Unit
 
Processing (Melt) Temp
°F
  
Extrusion
Nominal Value
Unit
 
Melt Temperature
°F
  
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.