PRE-ELEC ESD 4300 Premix OY Polyethylene, Low Density

Product Description

PRE-ELEC® ESD 4300 is a static dissipative thermoplastic compound based on PE-LD. The dissipative property is permanent and built into the polymer chain. PRE-ELEC® ESD 4300 has been developed for multilayer film blowing. It can also be blow moulded or injection moulded. Surface resistance values of 109 ohms (EOS/ESD S11.11-1993, IEC 61340-5-1) can be achieved with optimum processing parameters.

Typical applications include multilayer bags, sacks and bottles which give permanent ESD protection for the electronics, medical, pharmaceutical and agricultural industries. When
PRE-ELEC® ESD 4300 is used in the core layer and FDA approved polyolefin in the outer layers, a low charging and food approved film can be achieved. PRE-ELEC® ESD 4300 gives also good printability without treatment as it has low surface tension and can be coloured into various bright colours.

General

Material Status

Commercial: Active

Availability

Asia Pacific

Europe

North America

South America

Features

Barrier Resin

ESD Protection

Excellent Printability

Food Contact Acceptable

Good Colorability

Uses

Bags

Bottles

Film

Food Packaging

Media Packaging

Medical Packaging

Appearance

Colors Available

Forms

Granules

Processing Method

Blow Molding

Blown Film

Injection Molding

Physical	Nominal Value	Unit	Test Method
Specific Gravity
--			ASTM D792
--		g/cm³	ISO 1183
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)		g/10 min	ASTM D1238, ISO 1133
Electrical	Nominal Value	Unit	Test Method
Surface Resistivity		ohms	ASTM D257, IEC 60093
Additional Information
Static Decay Rate, IEC 61340-5-1 / FTMS 101C: <2 sec The value listed as Surface Resistance IEC 60093 and ASTM D257, were tested in accordance with IEC 61340-5- and EOS/ESD S11.11-1993.
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: PRE-ELEC ESD 4300, PREELEC ESD 4300, PRE-ELEC , PREELEC, PRE:ELEC, PRE/ELEC, PRE+ELEC, PRE_ELEC, PRE ELEC, PREELECESD4300, ESD 4300, ESD4300, Polyethylene, Low Density, Polyethylene Low Density, LDPE, Polyethylene, PE, Premix OY, PolyethyleneLowDensity, 4300ESD
Features
Features may also be described by the following terms: Electrostatic Discharge Protection, ESD Protection, Good Colorability, Excellent Printability, Printable.
Uses
Uses may also be described by the following terms: Food Packaging, Medical Packaging, Media Packaging.

Extrusion	Nominal Value	Unit
Drying Temperature		°F
Drying Time		hr
Melt Temperature		°F
Extrusion Notes
Blowing Ratio: >1.8 Screen PacK : standard

Notes

¹Typical properties: these are not to be construed as specifications.

PRE-ELEC ESD 4300

Low Density Polyethylene

Supplied by PREMIX OY