IDES Prospector Already have an account? Login Here

IDES

Surlyn® 1650SB

Ionomer

Supplied by DuPont Packaging & Industrial Polymers

The technical datasheet with complete property values for Surlyn® 1650SB is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
DuPont™ Surlyn® 1650SB is available for use in conventional blown and cast film extrusion and coextrusion equipment designed to process polyethylene resins. Slip and antiblock agents are added to reduce the film coefficient of friction and prevent film roll blocking.
General  
Material Status 
  • Commercial: Active
Availability 
  • Africa & Middle East
  • Asia Pacific
  • Europe
  • Latin America
  • North America
  • South America
Additive 
  • Antiblock
  • Slip
  
Features 
  • Antiblocking
  • Slip
  
Uses 
  • Cast Film
  • Film
  • Sheet
Forms 
  • Pellets
Processing Method 
  • Blown Film
  • Cast Film
  • Coextrusion
  • Sheet Extrusion
  
Physical
Nominal Value
Unit
Test Method
Specific Gravity
      
--
 
 ASTM D792
--
g/cm³
 ISO 1183
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ASTM D1238, ISO 1133
Thermal
Nominal Value
Unit
Test Method
Vicat Softening Temperature
°F
 ASTM D1525, ISO 306
Peak Melting Temperature
°F
 ASTM D3418, ISO 3146
Freezing Point
°F
 ASTM D3417
Related Terminology
This supplier and product may also be known by these terms: Surlin

Product names can be difficult to match. You may have searched any one of these terms to find this product: Surlyn® 1650SB, Surlyn 1650SB, Surlyn® , Surlyn, Surlyn1650SB, 1650 SB, 1650SB, Ionomer, DuPont P&IP, SB1650
Features
Features may also be described by the following terms: Slip, Unspecified Slip, Antiblocking, Unspecified Antiblock.
Uses
Uses may also be described by the following terms: Cast Film.
Extrusion
Nominal Value
Unit
 
Cylinder Zone 1 Temp.
°F
  
Cylinder Zone 2 Temp.
°F
  
Cylinder Zone 3 Temp.
°F
  
Cylinder Zone 4 Temp.
°F
  
Cylinder Zone 5 Temp.
°F
  
Adapter Temperature
°F
  
Melt Temperature
°F
  
Die Temperature
°F
  
Extrusion Notes
Blown Film Parameters:
Feed Zone: 135°C
Second Zone:160°C
Third Zone: 185°C
Fourth Zone: 185°C
Fifth Zone: 185°C
Adapter Zone: 185°C
Die Zone: 185°C
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.