IDES Prospector Already have an account? Login Here

IDES

HIPOLEN P® FC 31

Polypropylene Homopolymer

Supplied by HIPOL A.D.

The technical datasheet with complete property values for HIPOLEN P® FC 31 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Africa & Middle East
  • Europe
  
Features 
  • Good Adhesion
  • Low Neck-In
  
Uses 
  • Containers
  • Stationary Supplies
  
Forms 
  • Pellets
Processing Method 
  • Cast Film
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Melt Mass-Flow Rate (MFR) (230°C/1.2 kg)
g/10 min
 ASTM D1238
Mechanical
Nominal Value
Unit
Test Method
Tensile Elongation (Break)
%
 ASTM D638
Flexural Modulus
psi
 ASTM D790
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact (73°F)
ft·lb/in
 ASTM D256
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: HIPOLEN P® FC 31, HIPOLEN P FC 31, HIPOLEN P® , HIPOLEN P, HIPOLENPFC31, HIPOLENP, FC 31, FC31, Polypropylene Homopolymer, PP Homopolymer, Polypropylene, PP, Hipol, PolypropyleneHomopolymer, PPHomopolymer, 31FC
Features
Features may also be described by the following terms: Good Adhesion, Low Neck-in, Low Neck In.
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.