Elexar® EL-3954-80 Teknor Apex Thermoplastic Elastomer

General

Material Status

Availability

Uses

Appearance

Forms

Processing Method

Physical	Nominal Value	Unit	Test Method
Specific Gravity			ASTM D792
Melt Mass-Flow Rate (MFR) (230°C/2.16 kg)		g/10 min	ASTM D1238
Elastomers	Nominal Value	Unit	Test Method
Tensile Strength (Break)		psi	ASTM D412
Tensile Elongation (Break)		%	ASTM D412
Hardness	Nominal Value	Unit	Test Method
Durometer Hardness (Shore A)			ASTM D2240
Thermal	Nominal Value	Unit	Test Method
Brittleness Temperature		°F	ASTM D746
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Elexar® EL-3954-80, Elexar EL395480, Elexar® , Elexar, ElexarEL395480, EL, EL-3954-80, EL395480, EL:3954:80, EL/3954/80, EL+3954+80, EL_3954_80, EL 3954 80, EL3954, 395480, Thermoplastic Elastomer, TPE, Teknor Apex, ThermoplasticElastomer, 3954EL
Uses
Uses may also be described by the following terms: Appliance Wire Insulation, Industrial Cable Insulation, Appliance Wire Jacketing, Flexible Cord Jacketing, Terminal Cable Jacketing, Wire and Cable Applications, Wire & Cable Applications.

Injection	Nominal Value	Unit
Rear Temperature		°F
Middle Temperature		°F
Front Temperature		°F
Nozzle Temperature		°F
Processing (Melt) Temp		°F
Mold Temperature		°F
Injection Pressure		psi
Injection Rate
Back Pressure		psi
Screw Speed		rpm
Cushion		in
Injection Notes
Drying is not necessary. However, if moisture is a problem, dry the pellets for 2 to 4 hours at 150°F (65°C).
Extrusion	Nominal Value	Unit
Cylinder Zone 1 Temp.		°F
Cylinder Zone 2 Temp.		°F
Cylinder Zone 3 Temp.		°F
Cylinder Zone 5 Temp.		°F
Die Temperature		°F
Extrusion Notes
Screw Speed: 30 to 100 rpm

Notes

¹Typical properties: these are not to be construed as specifications.

Elexar® EL-3954-80