Elexar EL-1392B Teknor Apex Thermoplastic Elastomer

Product Description

RoHS compliance

General

Material Status

Availability

Uses

RoHS Compliance

Appearance

Forms

Processing Method

Physical	Nominal Value	Unit	Test Method
Specific Gravity			ASTM D792
Melt Mass-Flow Rate (MFR) (200°C/5.0 kg)		g/10 min	ASTM D1238
Elastomers	Nominal Value	Unit	Test Method
Tensile Stress (100% Strain)		psi	ASTM D412
Tensile Strength (Break)		psi	ASTM D412
Tensile Elongation (Break)		%	ASTM D412
Hardness	Nominal Value	Unit	Test Method
Durometer Hardness (Shore A)			ASTM D2240
Thermal	Nominal Value	Unit	Test Method
Brittleness Temperature		°F	ASTM D746
Aging	Nominal Value	Unit	Test Method
Change in Tensile Strength			ASTM D471
268°F, 3600 hr		%
277°F, 168 hr		%
316°F, 168 hr		%
Change in Ultimate Elongation			ASTM D471
268°F, 3600 hr		%
277°F, 168 hr		%
316°F, 168 hr		%
Electrical	Nominal Value	Unit	Test Method
Dielectric Strength		V/mil	ASTM D149
Dissipation Factor (77°F, 1 MHz)			ASTM D150
Flammability	Nominal Value	Unit	Test Method
Flame Rating - UL (0.0600 in)			UL 94
Oxygen Index		%	ASTM D2863
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Elexar® EL-1392B, Elexar EL1392B, Elexar® , Elexar, ElexarEL1392B, EL, EL 1392 B, EL-1392B, EL1392B, EL:1392B, EL/1392B, EL+1392B, EL_1392B, EL 1392B, EL1392, 1392B, Thermoplastic Elastomer, TPE, Teknor Apex, ThermoplasticElastomer, 1392EL
Uses
Uses may also be described by the following terms: Appliance Wire Insulation, Industrial Cable Insulation, Appliance Wire Jacketing, Flexible Cord Jacketing, Terminal Cable Jacketing, Wire and Cable Applications, Wire & Cable Applications.

Injection	Nominal Value	Unit
Rear Temperature		°F
Middle Temperature		°F
Front Temperature		°F
Nozzle Temperature		°F
Processing (Melt) Temp		°F
Mold Temperature		°F
Injection Pressure		psi
Injection Rate
Back Pressure		psi
Screw Speed		rpm
Cushion		in
Injection Notes
Drying is not necessary. However, if moisture is a problem, dry the pellets for 2 to 4 hours at 150°F (65°C).
Extrusion	Nominal Value	Unit
Cylinder Zone 1 Temp.		°F
Cylinder Zone 2 Temp.		°F
Cylinder Zone 3 Temp.		°F
Cylinder Zone 5 Temp.		°F
Die Temperature		°F
Extrusion Notes
Screw Speed: 30 to 100 rpm

Notes

¹Typical properties: these are not to be construed as specifications.

Elexar® EL-1392B