Elexar EL-1402E Teknor Apex Thermoplastic Elastomer

General

Material Status

Availability

Uses

Appearance

Forms

Processing Method

Physical	Nominal Value	Unit	Test Method
Specific Gravity			ASTM D792
Melt Mass-Flow Rate (MFR) (200°C/5.0 kg)		g/10 min	ASTM D1238
Elastomers	Nominal Value	Unit	Test Method
Tensile Stress			ASTM D412
100% Strain		psi
300% Strain		psi
Tensile Strength (Break)		psi	ASTM D412
Tensile Elongation (Break)		%	ASTM D412
Tear Strength		lbf/in	ASTM D624
Hardness	Nominal Value	Unit	Test Method
Durometer Hardness (Shore A)			ASTM D2240
Flammability	Nominal Value	Unit	Test Method
Flame Rating - UL (0.125 in)			UL 94
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Elexar® EL-1402E, Elexar EL1402E, Elexar® , Elexar, ElexarEL1402E, EL, EL 1402 E, EL-1402E, EL1402E, EL:1402E, EL/1402E, EL+1402E, EL_1402E, EL 1402E, EL1402, 1402E, Thermoplastic Elastomer, TPE, Teknor Apex, ThermoplasticElastomer, 1402EL

Injection	Nominal Value	Unit
Rear Temperature		°F
Middle Temperature		°F
Front Temperature		°F
Nozzle Temperature		°F
Processing (Melt) Temp		°F
Mold Temperature		°F
Injection Pressure		psi
Injection Rate
Back Pressure		psi
Screw Speed		rpm
Cushion		in
Injection Notes
Drying is not necessary. However, if moisture is a problem, dry the pellets for 1 to 2 hours at 176°F (80°C).
Extrusion	Nominal Value	Unit
Drying Temperature		°F
Drying Time		hr
Cylinder Zone 1 Temp.		°F
Cylinder Zone 2 Temp.		°F
Cylinder Zone 3 Temp.		°F
Cylinder Zone 5 Temp.		°F
Melt Temperature		°F
Die Temperature		°F
Extrusion Notes
Screw Speed: 30 to 100 rpm

Notes

¹Typical properties: these are not to be construed as specifications.

Elexar® EL-1402E