IDES Prospector Already have an account? Login Here

IDES

DISTRUMID 6 GMF30 HSUV

Polyamide 6

Glass\Mineral, 30%

Supplied by Distrupol

The technical datasheet with complete property values for DISTRUMID 6 GMF30 HSUV is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
Polyamide 6, 30% glass fibre and mineral filler, low viscosity, heat and UV stabilized, for injection moulding.
General  
Material Status 
  • Commercial: Active
Availability 
  • Europe
Filler / Reinforcement 
  • Glass\Mineral, 30% Filler by Weight
Additive 
  • Heat Stabilizer
  • UV Stabilizer
  
Features 
  • Good UV Resistance
  • Heat Stabilized
  • Low Viscosity
Forms 
  • Pellets
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ISO 1183
Mechanical
Nominal Value
Unit
Test Method
Tensile Modulus (73°F)
psi
 ISO 527-2/1
Tensile Stress (Break, 73°F)
psi
 ISO 527-2/5
Tensile Strain (Break, 73°F)
%
 ISO 527-2/5
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact Strength (73°F)
ft·lb/in²
 ISO 180/1A
Thermal
Nominal Value
Unit
Test Method
Vicat Softening Temperature
°F
 ISO 306/B50
Melting Temperature (DSC)
°F
 ISO 3146
Electrical
Nominal Value
Unit
Test Method
Surface Resistivity
ohms
 IEC 60093
Volume Resistivity
ohm·cm
 IEC 60093
Flammability
Nominal Value
Unit
Test Method
Flame Rating - UL (0.0315 in)
 
 UL 94
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: DISTRUMID 6 GMF30 HSUV, DISTRUMID , DISTRUMID6GMF30HSUV, 6 GMF 30 HSUV, 6 GMF30 HSUV, 6GMF, GMF30, 30HSUV, 6GMF30HSUV, Polyamide 6, Nylon 6, Polyamide, Nylon, pa6, Distrupol, Polyamide6, Nylon6, GMF6
Generic Name
Generic Name may also be described by the following terms: PA6.
Features
Features may also be described by the following terms: Low Viscosity, Heat Stabilized, Heat-ageing Stabilized, Heat Ageing Stabilized, Heat-aging Stabilized, Heat Aging Stabilized, Good UV Resistance, UV Resistant, Ultraviolet Resistant, Ultraviolet Light Resistant.
Injection
Nominal Value
Unit
 
Drying Temperature
°F
  
Drying Time
hr
  
Suggested Max Moisture
%
  
Processing (Melt) Temp
°F
  
Mold Temperature
°F
  
Back Pressure
psi
  
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.