IDES Prospector Already have an account? Login Here

IDES

Dynaprene® 1087A

Thermoplastic Elastomer

Supplied by Nantex Industry Co., Ltd.

The technical datasheet with complete property values for Dynaprene® 1087A is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
Dynaprene 1087A is an unreinforced TPE product for injection moulding in natural colour
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
Features 
  • Detergent Resistant
  • Good Chemical Resistance
  • Good Moldability
  • Good Wear Resistance
  • Good Weather Resistance
  • High Gloss
  • High Heat Resistance
  • Moisture Resistant
Appearance 
  • Natural Color
Forms 
  • Pellets
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Elastomers
Nominal Value
Unit
Test Method
Tensile Stress (100% Strain)
psi
 ASTM D412
Tensile Strength - Across Flow (Yield)
psi
 ASTM D412
Tensile Elongation - Across Flow (Break)
%
 ASTM D412
Compression Set (212°F, 22.0 hr)
%
 ASTM D395B
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore A, 5 sec)
 
 ASTM D2240
Aging
Nominal Value
Unit
Test Method
Change in Mass (250°F, 24 hr, in IRM 903 Oil)
%
 ASTM D471
Flammability
Nominal Value
Unit
Test Method
Flame Rating - UL (0.0295 in)
 
 UL 94
Additional Information
Moisture: 0.03%
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Dynaprene® 1087A, Dynaprene 1087A, Dynaprene® , Dynaprene, Dynaprene1087A, 1087 A, 1087A, Thermoplastic Elastomer, TPE, Nantex, ThermoplasticElastomer, A1087
Features
Features may also be described by the following terms: High Gloss, High Heat Resistance, Good Chemical Resistance, Chemical Resistant, Good Wear Resistance, Wear Resistant, Good Weather Resistance, Weather Resistant, Detergent Resistant, Detergent Resistance, Moisture Resistant, Water Resistant, Low Moisture Absorption, Low Water Absorption, Good Moldability.
Injection
Nominal Value
Unit
 
Rear Temperature
°F
  
Middle Temperature
°F
  
Front Temperature
°F
  
Nozzle Temperature
°F
  
Processing (Melt) Temp
°F
  
Mold Temperature
°F
  
Injection Pressure
psi
  
Holding Pressure
psi
  
Back Pressure
psi
  
Screw Speed
rpm
  
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.