IDES Prospector Already have an account? Login Here

IDES

Statiblend® PA12 CB

Polyamide 12

Supplied by TP Composites, Inc.

The technical datasheet with complete property values for Statiblend® PA12 CB is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Additive 
  • Carbon Black
Features 
  • Conductive
Appearance 
  • Black
Forms 
  • Pellets
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Molding Shrinkage - Flow
in/in
 ASTM D955
Water Absorption (24 hr)
%
 ASTM D570
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength (Yield)
psi
 ASTM D638
Tensile Elongation (Break)
%
 ASTM D638
Flexural Modulus
psi
 ASTM D790
Flexural Strength
psi
 ASTM D790
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact (0.125 in)
ft·lb/in
 ASTM D256
Thermal
Nominal Value
Unit
Test Method
Deflection Temperature Under Load (264 psi, Unannealed)
°F
 ASTM D648
CLTE - Flow
in/in/°F
 ASTM D696
Electrical
Nominal Value
Unit
Test Method
Surface Resistivity
ohm
 ASTM D257
Volume Resistivity
ohm·cm
 ASTM D257
Additional Information
Nominal Value
Unit
Test Method
TPCI #
 
  
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Statiblend® PA12 CB, Statiblend PA12 CB, Statiblend® , Statiblend, StatiblendPA12CB, PA 12 CB, PA12 CB, PA12, 12CB, PA12CB, Polyamide 12, Nylon 12, Polyamide, Nylon, TP Compos, Polyamide12, Nylon12, 12PA
Generic Name
Generic Name may also be described by the following terms: PA12.
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.