IDES Prospector Already have an account? Login Here

IDES

Dryflex® 47722

Styrene Ethylene Butylene Styrene Block Copolymer

Supplied by ELASTO

The technical datasheet with complete property values for Dryflex® 47722 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Europe
Features 
  • Good Chemical Resistance
  • Good Processability
  • Good Weather Resistance
  • Recyclable Material
  
Appearance 
  • Translucent
Forms 
  • Pellets
Processing Method 
  • Extrusion
  • Injection Molding
  
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ISO 2781
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ISO 1133
Molding Shrinkage
%
  
Elastomers
Nominal Value
Unit
Test Method
Tensile Stress (100% Strain)
psi
 ISO 37
Tensile Stress (Break)
psi
 ISO 37
Tensile Elongation (Break)
%
 ISO 37
Tear Strength 2
lbf/in
 ISO 34-1
Compression Set 3 (73°F, 24.0 hr)
%
 ISO 815
Hardness
Nominal Value
Unit
Test Method
Shore Hardness (Shore A)
 
 ISO 868
Thermal
Nominal Value
Unit
Test Method
Service Temperature 4
°F
  
Related Terminology
This supplier and product may also be known by these terms: British Vita

Product names can be difficult to match. You may have searched any one of these terms to find this product: Dryflex® 47722, Dryflex 47722, Dryflex® , Dryflex, Dryflex47722, 47722, Styrene Ethylene Butylene Styrene Block Copolymer, SEBS, Thermoplastic Elastomer, TPE, Elasto, StyreneEthyleneButyleneStyreneBlockCopolymer, ThermoplasticElastomer
Features
Features may also be described by the following terms: Good Weather Resistance, Weather Resistant, Good Chemical Resistance, Chemical Resistant, Good Processability, Easy Processing.
Injection
Nominal Value
Unit
 
Rear Temperature
°F
  
Middle Temperature
°F
  
Front Temperature
°F
  
Mold Temperature
°F
  
Extrusion
Nominal Value
Unit
 
Cylinder Zone 1 Temp.
°F
  
Cylinder Zone 2 Temp.
°F
  
Cylinder Zone 3 Temp.
°F
  
Cylinder Zone 4 Temp.
°F
  
Cylinder Zone 5 Temp.
°F
  
Notes
1Typical properties: these are not to be construed as specifications.
2Method C, Crescent
3Type B
4unstressed material
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.