IDES Prospector Already have an account? Login Here

IDES

Dow Corning® Q1-5036

Thermoset, Unspecified

Supplied by Dow Corning Corporation

The technical datasheet with complete property values for Dow Corning® Q1-5036 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Features 
  • Good Flow
  • Good Mold Release
  • Good Thermal Stability
  • High Strength
  
Uses 
  • Semiconductor Molding Compounds
Forms 
  • Pellets
Processing Method 
  • Injection Molding
  • Resin Transfer Molding
  
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Molding Shrinkage - Flow
in/in
 ASTM D955
Mechanical
Nominal Value
Unit
Test Method
Flexural Strength (Yield)
psi
 ASTM D790
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore D)
 
 ASTM D2240
Thermal
Nominal Value
Unit
Test Method
CLTE - Flow
in/in/°F
 ASTM D696
Thermal Conductivity
Btu·in/hr/ft²/°F
 ASTM C177
Electrical
Nominal Value
Unit
Test Method
Dielectric Constant (1 MHz)
 
 ASTM D150
Dissipation Factor (1 MHz)
 
 ASTM D150
Flammability
Nominal Value
Unit
Test Method
Flame Rating - UL (0.0625 in)
 
 UL 94
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Dow Corning® Q1-5036, Dow Corning Q15036, Dow Corning® , Dow Corning, DowCorningQ15036, DowCorning, Q 1, Q 1 5036, Q1-5036, Q15036, Q1:5036, Q1/5036, Q1+5036, Q1_5036, Q1 5036, Q1, 15036, Thermoset, Unspecified, Thermoset Unspecified, TS, Unspecified, TS Unspecified, Thermoset, TS, ThermosetUnspecified, TSUnspecified, 1Q
Features
Features may also be described by the following terms: Good Flow, Good Mold Release, Easy Release, Good Demolding, High Strength, Good Thermal Stability.
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.