IDES Prospector Already have an account? Login Here

IDES

Ultrason® P 3010

Polyphenylsulfone

Supplied by BASF Corporation

The technical datasheet with complete property values for Ultrason® P 3010 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
Ultrason P 3010 is an unfilled, flame retardant, higher viscosity injection molding PPSU grade, with improved chemical resistance.
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Features 
  • Flame Retardant
  • Good Chemical Resistance
  • High Viscosity
Agency Ratings 
 
RoHS Compliance 
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Density
lb/in³
 ISO 1183 2
Melt volume-flow rate (360°C/10.0 kg)
in³/10min
 ISO 1133 2
Molding Shrinkage
     ISO 294-4
Across Flow
%
  
Flow
%
  
Water Absorption
     ISO 62 2
Saturation
%
  
Equilibrium
%
  
Mechanical
Nominal Value
Unit
Test Method
Tensile modulus
psi
 ISO 527-2 2
Tensile Stress (Yield)
psi
 ISO 527-2 2
Tensile Strain (Yield)
%
 ISO 527-2 2
Impact
Nominal Value
Unit
Test Method
Charpy notched impact strength
     ISO 179/1eA 2
-22°F
ft·lb/in²
  
73°F
ft·lb/in²
  
Charpy impact strength
     ISO 179/1eU 2
-22°F
 
  
73°F
 
  
Thermal
Nominal Value
Unit
Test Method
Deflection Temperature Under Load (264 psi)
°F
 ISO 75-2 2
CLTE - Flow
in/in/°F
 ISO 11359-2
Electrical
Nominal Value
Unit
Test Method
Surface resistivity
ohms
 IEC 60093 2
Volume resistivity
ohm·in
 IEC 60093 2
Relative Permittivity
     IEC 60250 2
100 Hz
 
  
1 MHz
 
  
Dissipation Factor
     IEC 60250 2
100 Hz
 
  
1 MHz
 
  
Comparative tracking index
 
 IEC 60112 2
Electric strength
V/mil
 IEC 60243-1 2
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Ultrason® P 3010, Ultrason P 3010, Ultrason® P , Ultrason P, UltrasonP3010, UltrasonP, P 3010, P3010, 3010, Polyphenylsulfone, PPSU, Polysulfone, PSU, BASF, 3010P
Features
Features may also be described by the following terms: High Viscosity, Good Chemical Resistance, Chemical Resistant.
Agency Ratings
This plastic material has 2 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): NSF (1), EC (1).
Notes
1Typical properties: these are not to be construed as specifications.
2Tested in accordance with ISO 10350. 23°C/50%r.h. unless otherwise noted.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.