IDES Prospector Already have an account? Login Here

IDES

Hipec R-6103

Thermoset Elastomer

Supplied by Dow Corning Corporation

The technical datasheet with complete property values for Hipec R-6103 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Discontinued
Availability 
  • North America
Features 
  • Low Viscosity
Uses 
  • Semiconductor Protective Coatings
Appearance 
  • Clear/Transparent
Forms 
  • Pellets
Physical
Nominal Value
Unit
Test Method
Apparent Density
g/cm³
 ASTM D1895
Water Absorption (24 hr)
%
 ASTM D570
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore A)
 
 ASTM D2240
Thermal
Nominal Value
Unit
Test Method
CLTE - Flow
in/in/°F
 ASTM D696
Thermal Conductivity
Btu·in/hr/ft²/°F
 ASTM C177
Electrical
Nominal Value
Unit
Test Method
Volume Resistivity
ohm·cm
 ASTM D257
Dielectric Strength
V/mil
 ASTM D149
Dielectric Constant
     ASTM D150
1 kHz
 
  
1 MHz
 
  
Dissipation Factor
     ASTM D150
1 kHz
 
  
1 MHz
 
  
Optical
Nominal Value
Unit
Test Method
Refractive Index
 
 ASTM D542
Thermoset
Nominal Value
Unit
Test Method
Thermoset Components
      
Hardener
 
  
Resin
 
  
Pot Life (77°F)
min
  
Shelf Life (90°F)
wk
  
Thermoset Mix Viscosity (77°F)
cP
 ASTM D2393
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Hipec R-6103, Hipec R6103, Hipec , HipecR6103, R-6103, R6103, R:6103, R/6103, R+6103, R_6103, R 6103, Thermoset Elastomer, TSE, Dow Corning, ThermosetElastomer, 6103R
Features
Features may also be described by the following terms: Low Viscosity.
Uses
Uses may also be described by the following terms: Semiconductor Protective Coatings, Semiconductor Protective Coating.
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.