IDES Prospector Already have an account? Login Here

IDES

Alloy Exchange Reprocessed PC001

Acrylonitrile Butadiene Styrene + PC

Supplied by Alloy Exchange, Inc.

The technical datasheet with complete property values for Alloy Exchange Reprocessed PC001 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Recycled Content 
  • Yes
Appearance 
  • Black
  • Grey
  
Forms 
  • Pellets, Reprocessed
Physical
Nominal Value
Unit
Test Method
Specific Gravity 2
 
 ASTM D792A
Melt Mass-Flow Rate (MFR) 3, 4 (230°C/3.8 kg)
g/10 min
 ASTM D1238
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength 5, 6 (0.130 in)
psi
 ASTM D638
Tensile Elongation 5, 6 (Break, 0.130 in)
%
 ASTM D638
Flexural Modulus - Tangent 7, 8 (0.129 in, 1.97 in Span)
psi
 ASTM D790
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact 6 (0.127 in)
ft·lb/in
 ASTM D256
Thermal
Nominal Value
Unit
Test Method
Deflection Temperature Under Load 9 (264 psi, Unannealed)
°F
 ASTM D648
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Alloy Exchange Reprocessed PC001, Alloy Exchange Reprocessed , AlloyExchangeReprocessedPC001, AlloyExchangeReprocessed, ReprocessedPC 001, ReprocessedPC001, Reprocessed, PC 001, PC001, Acrylonitrile Butadiene Styrene + PC, Acrylonitrile Butadiene Styrene PC, Acrylonitrile Butadiene Styrene : PC, Acrylonitrile Butadiene Styrene / PC, Acrylonitrile Butadiene Styrene - PC, Acrylonitrile Butadiene Styrene _ PC, Acrylonitrile Butadiene Styrene PC, ABS+PC, ABSPC, ABS:PC, ABS/PC, ABS-PC, ABS_PC, ABS PC, Acrylonitrile Butadiene Styrene, ABS, Alloy Exchange, AcrylonitrileButadieneStyrenePC, AcrylonitrileButadieneStyrene, AcrylonitrileButadieneStyrene_PC, 001PC, 001ReprocessedPC
Notes
1Typical properties: these are not to be construed as specifications.
2No. of specimens tested: 3
3Procedure A
4No. of specimens tested: 2
Samples dried 24 hours at 93°C.
5Type I, 2.0 in/min
6No. of specimens tested: 5
7Method I (3 point load), 0.051 in/min
8Span: 50 mm
No. of specimens tested: 5
9Method A
No. of specimens tested: 2
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.