IDES Prospector Already have an account? Login Here

IDES

ALFATER XL® A75E 1GP0000

Thermoplastic Vulcanizate

Supplied by ALBIS PLASTIC GmbH

The technical datasheet with complete property values for ALFATER XL® A75E 1GP0000 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
Polymeric basis:
TPV-(EPDM+PP) (ISO 18064)
  • Blend of EPDM-phase, finely dispersed in a polypropylene-matrix;
EPDM is fully cross-linked by dynamic vulcanization
Special properties:
  • Low permanent distortion after tensile stress and pressure
  • High flexibility and useable mechanical properties about a wide temperature range (depending on stress: -40 until 125 °C)
  • Good resistance against weathering influences and ozone
  • Good resistance against many water solutions and alkaline medium
  • Excellent long-term ageing resistance against hot air until 125 °C
  • Also suitable for injection molding
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
  • Europe
  • North America
Features 
  • Alkali Resistant
  • Good Dimensional Stability
  • Good Flexibility
  • Good Heat Aging Resistance
  • Good Weather Resistance
  • Ozone Resistant
Processing Method 
  • Extrusion
  • Injection Molding
  
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ISO 1183
Elastomers
Nominal Value
Unit
Test Method
Tensile Stress (100% Strain)
psi
 ISO 37
Tensile Stress (Break)
psi
 ISO 37
Tensile Elongation (Break)
%
 ISO 37
Tear Strength 2
lbf/in
 ISO 34-1
Compression Set (212°F, 22.0 hr)
%
 ISO 815
Hardness
Nominal Value
Unit
Test Method
Shore Hardness (Shore A, 15 sec)
 
 ISO 868
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: ALFATER XL® A75E 1GP0000, ALFATER XL A75E 1GP0000, ALFATER XL® , ALFATER XL, ALFATERXLA75E1GP0000, ALFATERXL, A 75 E 1 GP 0000, A75E 1GP0000, A75, 75E, E1, 1GP, GP0000, A75E1GP0000, Thermoplastic Vulcanizate, TPV, Thermoplastic Elastomer, TPE, Albis Euro, ThermoplasticVulcanizate, ThermoplasticElastomer, 75A
Features
Features may also be described by the following terms: Good Dimensional Stability, Dimensionally Stable, Good Weather Resistance, Weather Resistant, Good Heat Aging Resistance, Good Flexibility, Flexible.
Extrusion
Nominal Value
Unit
 
Drying Temperature
°F
  
Drying Time
hr
  
Melt Temperature
°F
  
Notes
1Typical properties: these are not to be construed as specifications.
2Method Ba, Angle (Unnicked)
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.