IDES Prospector Already have an account? Login Here

IDES

HIPTEN® 22020

Low Density Polyethylene

Supplied by HIP-PetroHemija

The technical datasheet with complete property values for HIPTEN® 22020 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
HIPTEN® 22020 is low density polyethylene resin developed for film extrusion. This grade has good mechanical and optical properties and good draw down characteristics. Film produced from this grade has good appearance and heat sealability, good moisture barrier and adhesion properties.

Applications:
Production of laminated food-packaging materials.

HIPTEN® 22020 has Health Certificate issued by Institute for Health Protection of Serbia.
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
  • Europe
 
Features 
  • Food Contact Acceptable
  • Good Adhesion
  • Good Drawdown
  • Good Heat Seal
  • Moisture Barrier
  • Opticals
  • Pleasing Surface Appearance
  • Recyclable Material
Uses 
  • Film
  • Food Packaging
  • Laminates
Agency Ratings 
Forms 
  • Pellets
Processing Method 
  • Film Extrusion
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
ISO 1183/D
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
ISO 1133
Mechanical
Nominal Value
Unit
Test Method
Tensile Stress
    ISO 527-2
Yield
psi
 
Break
psi
 
Tensile Strain (Break)
%
ISO 527-2
Films
Nominal Value
Unit
Test Method
Tensile Strength
    ISO 1184
TD: Yield
psi
 
MD: Break
psi
 
TD: Break
psi
 
Tensile Elongation
    ISO 1184
MD: Break
%
 
TD: Break
%
 
Dart Drop Impact 2
g
ASTM D1709A
Elmendorf Tear Strength
    ASTM D1922
MD
g
 
TD
g
 
Hardness
Nominal Value
Unit
Test Method
Shore Hardness (Shore D)
 
ISO 868
Thermal
Nominal Value
Unit
Test Method
Vicat Softening Temperature
°F
ISO 306
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: HIPTEN® 22020, HIPTEN 22020, HIPTEN® , HIPTEN, HIPTEN22020, 22020, Polyethylene, Low Density, Polyethylene Low Density, LDPE, Polyethylene, PE, HIP-PetroHemija, PolyethyleneLowDensity
Features
Features may also be described by the following terms: Good Adhesion, Good Drawdown, Good draw down, Good Heat Seal, Moisture Barrier, Pleasing Surface Appearance.
Uses
Uses may also be described by the following terms: Food Packaging.
Agency Ratings
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): EC (1).
Extrusion
Nominal Value
Unit
 
Melt Temperature
°F
 
Extrusion Notes
Blow-up ratio: 2:1 to 3:1
Notes
1Typical properties: these are not to be construed as specifications.
2F50
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.