Already have an account?
Login Here
IDES
Kern EVA
Ethylene Vinyl Acetate Copolymer
Supplied by Kern GmbH
The technical datasheet with complete property values for Kern EVA is available to members of the
Prospector Plastics Database
.
Register to view full datasheet
.
Register to View Full Datasheet
General
Material Status
Commercial: Active
Availability
Europe
Appearance
Translucent
Processing Method
Injection Molding
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
ISO 1183
Water Absorption
ISO 62
Saturation, 73°F
%
Equilibrium, 73°F, 50% RH
%
Mechanical
Nominal Value
Unit
Test Method
Tensile Modulus
psi
ISO 527-2
Tensile Stress
ISO 527-2
Yield
psi
Break
psi
Tensile Strain
(Break)
%
ISO 527-2
Impact
Nominal Value
Unit
Test Method
Charpy Notched Impact Strength
(73°F)
ISO 179/1eA
Notched Izod Impact Strength
(73°F)
ISO 180/2A
Thermal
Nominal Value
Unit
Test Method
Max. Continuous Use Temperature
°F
Brittleness Temperature
°F
Glass Transition Temperature
°F
ISO 11357-2
CLTE
ISO 11359-2
Flow
in/in/°F
Transverse
in/in/°F
Thermal Conductivity
Btu·in/hr/ft²/°F
DIN 52612
Electrical
Nominal Value
Unit
Test Method
Surface Resistivity
ohms
IEC 60093
Volume Resistivity
ohm·cm
IEC 60093
Dielectric Constant
(50 Hz)
IEC 60250
Dissipation Factor
(50 Hz)
IEC 60250
Comparative Tracking Index
V
IEC 60112
Additional Information
Nominal Value
Unit
Test Method
Material Number
Short Time Use Temperature
°F
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Kern EVA, Kern , KernEVA, EVA, Ethylene Vinyl Acetate Copolymer, Polyethylene, PE, EthyleneVinylAcetateCopolymer
Notes
1
Typical properties: these are not to be construed as specifications.
Copyright © 2012
IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.