IDES Prospector Already have an account? Login Here

IDES

SMOKEGUARD™ O 405

Polyolefin

Supplied by AlphaGary

The technical datasheet with complete property values for SMOKEGUARD™ O 405 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
A 105°C RATED, FLAME RETARDED THERMOPLASTIC INSULATION AND SPLINE COMPOUND INTENDED FOR COMMNICATIONS CABLE.
General  
Material Status 
  • Commercial: Active
Availability 
  • Europe
  • North America
  
Features 
  • Flame Retardant
Uses 
  • Cable Jacketing
  • Communication Wire Insulation
  
Appearance 
  • Natural Color
Forms 
  • Pellets
Processing Method 
  • Extrusion
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ASTM D1238
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength (Yield, 0.0300 in)
psi
 ASTM D638
Tensile Elongation (Break, 0.0300 in)
%
 ASTM D638
Aging
Nominal Value
Unit
Test Method
Change in Tensile Strength in Air 2 (277°F, 168 hr)
%
 ASTM D573
Change in Ultimate Elongation in Air 2 (277°F, 168 hr)
%
 ASTM D573
Electrical
Nominal Value
Unit
Test Method
Dielectric Constant (73°F, 100 MHz)
 
 ASTM D150
Dissipation Factor (73°F, 100 MHz)
 
 ASTM D150
Flammability
Nominal Value
Unit
Test Method
Oxygen Index (0.125 in)
%
 ASTM D2863
Related Terminology
This supplier and product may also be known by these terms: Alpha Gary

Product names can be difficult to match. You may have searched any one of these terms to find this product: SMOKEGUARD™ O 405, SMOKEGUARD O 405, SMOKEGUARD™ O , SMOKEGUARD O, SMOKEGUARDO405, SMOKEGUARDO, O 405, O405, 405, Polyolefin, Unspecified, Polyolefin Unspecified, Polyolefin, AlphaGary, PolyolefinUnspecified, 405O
Uses
Uses may also be described by the following terms: Communication Wire Insulation.
Extrusion
Nominal Value
Unit
 
Cylinder Zone 1 Temp.
°F
  
Cylinder Zone 2 Temp.
°F
  
Cylinder Zone 3 Temp.
°F
  
Cylinder Zone 4 Temp.
°F
  
Cylinder Zone 5 Temp.
°F
  
Adapter Temperature
°F
  
Melt Temperature
°F
  
Die Temperature
°F
  
Extrusion Notes
Screw Design: Standard P.E. screw 3.5:1 compression ratio
Notes
1Typical properties: these are not to be construed as specifications.
2UL Standard, 30 mil
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.