IDES Prospector Already have an account? Login Here

IDES

Thermoset Plastics 104

Epoxy; Epoxide

Supplied by Thermoset, Lord Chemical Products

The technical datasheet with complete property values for Thermoset Plastics 104 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Features 
  • Good Adhesion
  • Low Viscosity
  
Uses 
  • Adhesives
Forms 
  • Paste
Physical
Nominal Value
Unit
Test Method
Apparent Density
g/cm³
 ASTM D1895
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength (Yield)
psi
 ASTM D638
Flexural Strength (Yield)
psi
 ASTM D790
Compressive Strength
psi
 ASTM D695
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore D)
 
 ASTM D2240
Thermoset
Nominal Value
Unit
Test Method
Thermoset Components
      
Hardener
 
  
Resin
 
  
Thermoset Mix Viscosity (77°F)
cP
 ASTM D2393
Demold Time (77°F)
min
  
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Thermoset Plastics 104, Thermoset Plastics , ThermosetPlastics104, ThermosetPlastics, Plastics 104, Plastics104, Plastics, 104, Epoxy; Epoxide, Epoxy Epoxide, Epoxy, Lord Thermoset, EpoxyEpoxide, 104Plastics
Features
Features may also be described by the following terms: Good Adhesion, Low Viscosity.
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.