IDES Prospector Already have an account? Login Here

IDES

Elastocon® 8028N

Thermoplastic Elastomer

Supplied by Elastocon TPE Technologies

The technical datasheet with complete property values for Elastocon® 8028N is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
Elastocon® 8028N is a colorable thermoplastic elastomer formulated for applications that require rubber-like properties and a good surface finish. Elastocon® 8028N is FDA compliant and well suited for consumer goods and industrial applications requiring U.V. stability. Elastocon® 8028N can be overmolded to polypropylene.
General  
Material Status 
  • Commercial: Active
Availability 
  • Europe
  • North America
  
Additive 
  • UV Stabilizer
Features 
  • Good Colorability
  • Good Surface Finish
  • Good UV Resistance
  • Soft
  
Uses 
  • Consumer Applications
  • Industrial Applications
  • Overmolding
Agency Ratings 
Forms 
  • Pellets
Processing Method 
  • Blow Molding
  • Extrusion
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Molding Shrinkage - Flow
in/in
 ASTM D955
Elastomers
Nominal Value
Unit
Test Method
Tensile Stress (100% Strain)
psi
 ASTM D412
Tensile Strength (Yield)
psi
 ASTM D412
Tensile Elongation (Break)
%
 ASTM D412
Compression Set (73°F, 22.0 hr)
%
 ASTM D395B
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore A)
 
 ASTM D2240
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Elastocon® 8028N, Elastocon 8028N, Elastocon® , Elastocon, Elastocon8028N, 8028 N, 8028N, Thermoplastic Elastomer, TPE, ThermoplasticElastomer, N8028
Features
Features may also be described by the following terms: Good Surface Finish, Good UV Resistance, UV Resistant, Ultraviolet Resistant, Ultraviolet Light Resistant, Good Colorability.
Agency Ratings
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1).
Injection
Nominal Value
Unit
 
Rear Temperature
°F
  
Front Temperature
°F
  
Nozzle Temperature
°F
  
Mold Temperature
°F
  
Injection Rate
 
  
Back Pressure
psi
  
Extrusion
Nominal Value
Unit
 
Hopper Temperature
°F
  
Cylinder Zone 1 Temp.
°F
  
Cylinder Zone 2 Temp.
°F
  
Cylinder Zone 3 Temp.
°F
  
Cylinder Zone 4 Temp.
°F
  
Cylinder Zone 5 Temp.
°F
  
Die Temperature
°F
  
Extrusion Notes
Compression ratio: 2.5 to 3.0
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.