IDES Prospector Already have an account? Login Here

IDES

Thermoset Plastics 322

Epoxy; Epoxide

Unspecified Filler\Reinfor.

Supplied by Thermoset, Lord Chemical Products

The technical datasheet with complete property values for Thermoset Plastics 322 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Filler / Reinforcement 
  • Unspecified Filler\Reinfor.
Features 
  • Electrically Insulating
  • Good Thermal Shock Resistance
  • Low Exotherm
  • Semi Rigid
  
Uses 
  • Electronic Insulation
Appearance 
  • Black
Forms 
  • Pellets
Processing Method 
  • Casting
  • Encapsulating
  
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Water Absorption (24 hr)
%
 ASTM D570
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength (Yield)
psi
 ASTM D638
Tensile Elongation (Yield)
%
 ASTM D638
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact
ft·lb/in
 ASTM D256
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore D)
 
 ASTM D2240
Electrical
Nominal Value
Unit
Test Method
Volume Resistivity
ohm·cm
 ASTM D257
Dielectric Constant (1 MHz)
 
 ASTM D150
Dissipation Factor (1 MHz)
 
 ASTM D150
Thermoset
Nominal Value
Unit
Test Method
Thermoset Components
      
Hardener
 
  
Resin
 
  
Thermoset Mix Viscosity (77°F)
cP
 ASTM D2393
Demold Time (77°F)
min
  
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Thermoset Plastics 322, Thermoset Plastics , ThermosetPlastics322, ThermosetPlastics, Plastics 322, Plastics322, Plastics, 322, Epoxy; Epoxide, Epoxy Epoxide, Epoxy, Lord Thermoset, EpoxyEpoxide, 322Plastics
Features
Features may also be described by the following terms: Low Exotherm, Semi-Rigid, Semi Rigid, Good Thermal Shock Resistance, Thermal Shock Resistant.
Uses
Uses may also be described by the following terms: Electronic Insulation.
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.