Already have an account?
Login Here
IDES
4LEX® 10F13500
Polycarbonate
Supplied by 4Plas
The technical datasheet with complete property values for 4LEX® 10F13500 is available to members of the
Prospector Plastics Database
.
Register to view full datasheet
.
Register to View Full Datasheet
General
Material Status
Commercial: Active
Availability
Europe
Features
Halogen Free
Appearance
Colors Available
Processing Method
Injection Molding
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
ISO 1183
Melt Mass-Flow Rate (MFR)
g/10 min
ISO 1133
Molding Shrinkage - Flow
%
ISO 2557
Water Absorption
(Saturation, 73°F)
%
ISO 62
Mechanical
Nominal Value
Unit
Test Method
Tensile Modulus
(73°F)
psi
ISO 527-2
Tensile Stress
(Break, 73°F)
psi
ISO 527-2
Tensile Strain
(Break, 73°F)
%
ISO 527-2
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact Strength
(73°F)
ft·lb/in²
ISO 180/1A
Thermal
Nominal Value
Unit
Test Method
Heat Deflection Temperature
66 psi, Unannealed
°F
ISO 75-2/B
264 psi, Unannealed
°F
ISO 75-2/A
Vicat Softening Temperature
°F
ISO 306/B
Flammability
Nominal Value
Unit
Test Method
Flame Rating - UL
UL 94
0.0630 in
0.126 in
Glow Wire Ignition Temperature
(0.0787 in)
°F
IEC 60695-2-13
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: 4LEX® 10F13500, 4LEX 10F13500, 4LEX® , 4LEX, 4LEX10F13500, 10 F 13500, 10F13500, 10F, F13500, Polycarbonate, PC, 4Plas, F10
Features
Features may also be described by the following terms: Zero Halogen Content, Halogen Free.
Injection
Nominal Value
Unit
Drying Temperature
°F
Drying Time
hr
Suggested Max Regrind
%
Rear Temperature
°F
Middle Temperature
°F
Front Temperature
°F
Processing (Melt) Temp
°F
Mold Temperature
°F
Injection Rate
Injection Notes
Back Pressure: Low
Injection Pressure: High
Notes
1
Typical properties: these are not to be construed as specifications.
Copyright © 2012
IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.