IDES Prospector Already have an account? Login Here

IDES

4LAC® 18H22220

Acrylonitrile Butadiene Styrene

Glass Bead, 20%

Supplied by 4Plas

The technical datasheet with complete property values for 4LAC® 18H22220 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Europe
Filler / Reinforcement 
  • Glass Bead, 20% Filler by Weight
Features 
  • Good Stiffness
  • Low Warpage
  
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Melt Mass-Flow Rate (MFR)
g/10 min
 ISO 1133
Mechanical
Nominal Value
Unit
Test Method
Tensile Stress (Yield, 73°F)
psi
 ISO 527-2
Tensile Strain (Break, 73°F)
%
 ISO 527-2
Flexural Modulus (73°F)
psi
 ISO 178
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact
     ASTM D256
32°F
ft·lb/in
  
73°F
ft·lb/in
  
Thermal
Nominal Value
Unit
Test Method
Heat Deflection Temperature (264 psi, Unannealed)
°F
 ISO 75-2/A
Vicat Softening Temperature
°F
 ISO 306/B
Ball Pressure Test (167°F)
 
 IEC 60335-1
Electrical
Nominal Value
Unit
Test Method
Comparative Tracking Index
V
 IEC 60112
Flammability
Nominal Value
Unit
Test Method
Flame Rating - UL (0.126 in)
 
 UL 94
Glow Wire Ignition Temperature (0.0787 in)
°F
 IEC 60695-2-13
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: 4LAC® 18H22220, 4LAC 18H22220, 4LAC® , 4LAC, 4LAC18H22220, 18 H 22220, 18H22220, 18H, H22220, Acrylonitrile Butadiene Styrene, ABS, 4Plas, AcrylonitrileButadieneStyrene, H18
Features
Features may also be described by the following terms: Good Stiffness, Low Warpage, Low Warp.
Injection
Nominal Value
Unit
 
Drying Temperature
°F
  
Drying Time
hr
  
Suggested Max Regrind
%
  
Rear Temperature
°F
  
Middle Temperature
°F
  
Front Temperature
°F
  
Processing (Melt) Temp
°F
  
Mold Temperature
°F
  
Injection Rate
 
  
Injection Notes
Back Pressure: High
Injection Pressure: High
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.