IDES Prospector Already have an account? Login Here

IDES

Qenos PE HD0790

High Density Polyethylene

Supplied by Qenos Pty Ltd

The technical datasheet with complete property values for Qenos PE HD0790 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
HD0790 ia an injection molding grade of High Density Polyethylene with a good balance between flow and impact resistance.

HD0790 is intended for use in production of moldings such as sealant cartridges, crates and closures. Addition of a UV stabilizer should be considered where the intended application involves intermittent to extended exposure to sunlight. Suitability for use in any application should be determined by appropriate performance testing.
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
Features 
  • Good Flow
  • Good Impact Resistance
 
Uses 
  • Closures
  • Crates
  • Sealing Devices
Agency Ratings 
 
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
ASTM D1505
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
ASTM D1238
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength (Yield)
psi
ASTM D638
Flexural Modulus
psi
ASTM D790
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact (-22°F)
ft·lb/in
ASTM D256A
Hardness
Nominal Value
Unit
Test Method
Ball Indentation Hardness
psi
ISO 2039-1
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Qenos PE HD0790, Qenos PE , QenosPEHD0790, QenosPE, PEHD 0790, PEHD0790, PE, HD 0790, HD0790, Polyethylene, High Density, Polyethylene High Density, HDPE, Polyethylene, Qenos, PolyethyleneHighDensity, 0790HD, 0790PEHD
Features
Features may also be described by the following terms: Good Flow, Good Impact Resistance.
Agency Ratings
This plastic material has 2 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1), AS (1).
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.