IDES Prospector Already have an account? Login Here

IDES

KRATON® D1160 NS

Styrene Isoprene Styrene Block Copolymer

Supplied by Kraton Polymers LLC

The technical datasheet with complete property values for KRATON® D1160 NS is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
Kraton® D-1160 polymer is a clear linear triblock copolymer based on styrene and isoprene with bound styrene of 18.5% mass.

Kraton D-1160NS is supplied from the Netherlands as porous pellets dusted with an amorphous silica.

Kraton D-1160NS polymer is used in formulating adhesives, hot melt pressure sensitive adhesives in particular.
General  
Material Status 
  • Commercial: Active
Availability 
  • Africa & Middle East
  • Asia Pacific
  • Europe
  • North America
  • South America
Additive 
  • Antioxidant (600 ppm)
Features 
  • Block Copolymer
Uses 
  • Adhesives
Appearance 
  • Clear/Transparent
Forms 
  • Pellets
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
ISO 2781
Apparent Density
g/cm³
ASTM D1895B
Melt Mass-Flow Rate (MFR) (200°C/5.0 kg)
g/10 min
ISO 1133
Solution Viscosity 2
mPa·s
Internal Method
Bound Styrene
%
Internal Method
Ash Content
%
ISO 247-B
Molecular Weight
g/mol
Internal Method
Volatile Matter
 
Internal Method
Elastomers
Nominal Value
Unit
Test Method
Tensile Stress 3 (300% Strain)
psi
ISO 37
Tensile Stress 3 (Yield)
psi
ISO 37
Tensile Elongation 3 (Break)
%
ISO 37
Hardness
Nominal Value
Unit
Test Method
Shore Hardness 4 (Shore A, 30 sec)
 
ISO 868
Additional Information
Nominal Value
Unit
Test Method
Antioxidant Additive 5
%
Internal Method
Extractables
%
Internal Method
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: KRATON® D1160 NS, KRATON D1160 NS, KRATON® , KRATON, KRATOND1160NS, D 1160 NS, D1160 NS, D1160, 1160NS, D1160NS, Styrene Isoprene Styrene Block Copolymer, SIS, Thermoplastic Elastomer, TPE, StyreneIsopreneStyreneBlockCopolymer, ThermoplasticElastomer, 1160D
Features
Features may also be described by the following terms: Block Copolymer.
Notes
1Typical properties: these are not to be construed as specifications.
2Measured on 25% mass solution in toluene at 25°C using a Brookfield viscometer, LTF or LTV model
3Measured on films cast from a solution in toluene
4Measured on compression molded slabs
5Primary phenolic antioxidant
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.