IDES Prospector Already have an account? Login Here

IDES

KRATON® D1124 B

Styrene Isoprene Styrene Block Copolymer

Supplied by Kraton Polymers LLC

The technical datasheet with complete property values for KRATON® D1124 B is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
Kraton D1124 B is a clear, branched triblock copolymer based on styrene and isoprene with a polystyrene content of 30%. It is supplied from South America in the physical form identified below.

  • Kraton D1124 BT - supplied as a porous pellet dusted with talc

Kraton D1124 B is used as an ingredient in formulating adhesives, sealants and coatings. It may also find use as a modifier of bitumen and polymers.
General  
Material Status 
  • Commercial: Active
Availability 
  • South America
Additive 
  • Antioxidant (1450 ppm)
Features 
  • Block Copolymer
  • High Clarity
  
Uses 
  • Adhesives
  • Coating Applications
  • Plastics Modification
  • Sealants
  
Appearance 
  • Clear/Transparent
Forms 
  • Pellets
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ISO 2781
Melt Mass-Flow Rate (MFR) (200°C/5.0 kg)
g/10 min
 ISO 1133
Solution Viscosity 2
mPa·s
 Internal Method
Bound Styrene
%
 Internal Method
Ash Content - BT
wt%
 Internal Method
Polystyrene Content
%
 Internal Method
Total Extractables
%
 Internal Method
Volatile Matter
%
 Internal Method
Elastomers
Nominal Value
Unit
Test Method
Tensile Stress (300% Strain)
psi
 ISO 37
Tensile Stress (Yield)
psi
 ISO 37
Tensile Elongation (Break)
%
 ISO 37
Hardness
Nominal Value
Unit
Test Method
Shore Hardness (Shore A, 30 sec, Compression Molded)
 
 ISO 868
Additional Information
Nominal Value
Unit
Test Method
Antioxidant Additive
%
 Internal Method
Diblock Content
%
  
Styrene/Rubber ratio
%
  
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: KRATON® D1124 B, KRATON D1124 B, KRATON® , KRATON, KRATOND1124B, D 1124 B, D1124 B, D1124, 1124B, D1124B, Styrene Isoprene Styrene Block Copolymer, SIS, Thermoplastic Elastomer, TPE, StyreneIsopreneStyreneBlockCopolymer, ThermoplasticElastomer, 1124D
Features
Features may also be described by the following terms: Block Copolymer, High Clarity.
Uses
Uses may also be described by the following terms: Sanitary Products, Plastics Modification, Plastic Modification.
Notes
1Typical properties: these are not to be construed as specifications.
225%w toluene solution at 25°C
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.