IDES Prospector Already have an account? Login Here

IDES

Kingfa FRHIPS-220

High Impact Polystyrene

Supplied by Kingfa

The technical datasheet with complete property values for Kingfa FRHIPS-220 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
  • North America
  
Features 
  • Good Electrical Properties
  • High Gloss
  
Uses 
  • Appliances
  • Electrical/Electronic Applications
  • Housings
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Melt Mass-Flow Rate (MFR) (200°C/5.0 kg)
g/10 min
 ASTM D1238
Molding Shrinkage - Flow
in/in
 ASTM D955
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength 2 (Yield)
psi
 ASTM D638
Tensile Elongation 2 (Break)
%
 ASTM D638
Flexural Modulus 3
psi
 ASTM D790
Flexural Strength 3
psi
 ASTM D790
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact (73°F, 0.126 in)
ft·lb/in
 ASTM D256
Thermal
Nominal Value
Unit
Test Method
Deflection Temperature Under Load (264 psi, Unannealed, 0.252 in)
°F
 ASTM D648
Electrical
Nominal Value
Unit
Test Method
Volume Resistivity
ohm·cm
 ASTM D257
Flammability
Nominal Value
Unit
Test Method
Flame Rating - UL
     UL 94
0.0630 in
 
  
0.126 in
 
  
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Kingfa FRHIPS-220, Kingfa FRHIPS220, Kingfa , KingfaFRHIPS220, FRHIPS, FRHIPS-220, FRHIPS220, FRHIPS:220, FRHIPS/220, FRHIPS+220, FRHIPS_220, FRHIPS 220, PS, Polystyrene, High Impact, Polystyrene High Impact, PS (HIPS), PS HIPS, Polystyrene, PolystyreneHighImpact, PSHIPS, 220FRHIPS
Features
Features may also be described by the following terms: Good Electrical Properties, High Gloss.
Uses
Uses may also be described by the following terms: Housings, Housing, Electrical Applications, Electronic Applications, Electrical/Electronic Applications, Electrical Sector.
Injection
Nominal Value
Unit
 
Drying Temperature
°F
  
Drying Time
hr
  
Rear Temperature
°F
  
Middle Temperature
°F
  
Front Temperature
°F
  
Processing (Melt) Temp
°F
  
Mold Temperature
°F
  
Injection Rate
 
  
Back Pressure
psi
  
Notes
1Typical properties: these are not to be construed as specifications.
22.0 in/min
30.079 in/min
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.