IDES Prospector Already have an account? Login Here

IDES

INSPIRE™ 222

Polypropylene Homopolymer

Supplied by Braskem America Inc.

The technical datasheet with complete property values for INSPIRE™ 222 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
INSPIRE™ 222 Performance Polymer is intended for use in extrusion and thermoforming processes. It is especially suited in applications requiring excellent clarity and good stiffness.

  • Contains a nucleating agent
  • High clarity

Complies with:
  • European Commission Regulation (EU) No 10/2011
  • U.S. FDA FCN 909
  • Canadian HPFB No Objection with Limitations
Consult the regulations for complete details.
General  
Material Status 
  • Commercial: Active
Availability 
  • Latin America
  • North America
  
Agency Ratings 
Forms 
  • Pellets
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Melt Mass-Flow Rate (MFR) (230°C/2.16 kg)
g/10 min
 ASTM D1238
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength 2 (Yield)
psi
 ASTM D638
Tensile Elongation 2 (Yield)
%
 ASTM D638
Flexural Modulus - 1% Secant 2
psi
 ASTM D790
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact 2
     ASTM D256A
32°F
ft·lb/in
  
73°F
ft·lb/in
  
Thermal
Nominal Value
Unit
Test Method
Deflection Temperature Under Load 2 (66 psi, Unannealed)
°F
 ASTM D648
Melting Temperature (DSC)
°F
 Internal Method
Optical
Nominal Value
Unit
Test Method
Haze
     ASTM D1003
40.0 mil, Injection Molded 3
%
  
10.0 mil, Thermoformed 4
%
  
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: INSPIRE™ 222, INSPIRE 222, INSPIRE™ , INSPIRE, INSPIRE222, 222, Polypropylene Homopolymer, PP Homopolymer, Polypropylene, PP, Braskem PP, PolypropyleneHomopolymer, PPHomopolymer
Agency Ratings
This plastic material has 3 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): EU (1), HPFB (Canada) (1), FDA (1).
Notes
1Typical properties: these are not to be construed as specifications.
2Testing performed on ASTM D 638 Type I specimen, molded and tested in accordance with ASTM D 4101. Properties will vary with changes in molding conditions and aging time.
3Measured through a 40mil thick injection molded plaque.
4Measured through a 10mil thick sidewall of a 16oz thermoformed cup.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.