IDES Prospector Already have an account? Login Here

IDES

INEOS LDPE 23T930

Low Density Polyethylene

Supplied by INEOS Olefins & Polymers Europe

The technical datasheet with complete property values for INEOS LDPE 23T930 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
23T930 is a low-density polyethylene intended for injection rnoulding. It is a high MFR material, having good flow properties and allowing short cycle tirne. The rnoulded article is characterised by low degree of built-in stress, good stiffness and high gloss.

Applications:
23T930 is recommended for injection moulding of flexible products which require good flow properties and short cycle time. The material is especially suitable for thin walled products like caps and closures, household goods and toys.
General  
Material Status 
  • Commercial: Active
Availability 
  • Europe
Features 
  • Fast Molding Cycle
  • Good Flexibility
  • Good Stiffness
  • High Flow
  • High Gloss
  • Low Density
Uses 
  • Caps
  • Closures
  • Household Goods
  • Thin-walled Parts
  • Toys
RoHS Compliance 
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ISO 1183
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ISO 1133
Mechanical
Nominal Value
Unit
Test Method
Tensile Modulus
psi
 ISO 527-2/1
Tensile Strain (Break)
%
 ISO 527-2
Impact
Nominal Value
Unit
Test Method
Tensile Impact Strength
ft·lb/in²
 ISO 8256/1
Hardness
Nominal Value
Unit
Test Method
Shore Hardness (Shore D)
 
 ISO 868
Thermal
Nominal Value
Unit
Test Method
Vicat Softening Temperature
°F
 ISO 306/A
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: INEOS LDPE 23T930, INEOS LDPE , INEOSLDPE23T930, INEOSLDPE, LDPE 23 T 930, LDPE23T930, LDPE23, LDPE, 23 T 930, 23T930, 23T, T930, Polyethylene, Low Density, Polyethylene Low Density, Polyethylene, PE, Ineos Polyolefins, PolyethyleneLowDensity, T23, 23LDPE
Features
Features may also be described by the following terms: Good Flexibility, Flexible, Fast Cycle, Rapid Cycle, Productivity, Fast Molding Cycle, High Gloss, High Flow, High Melt, High MFI, Low Density, Low Specific Gravity, Good Stiffness.
Uses
Uses may also be described by the following terms: Closure Caps, Caps, Cap, Household Goods, Housewares, Thin-walled Parts, Thin Walled Parts, Thin-wall Parts, Thin wall Parts, Thinwall Parts.
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.