IDES Prospector Already have an account? Login Here

IDES

INEOS Wire & Cable BPD2000E

Low Density Polyethylene

Supplied by INEOS Olefins & Polymers Europe

The technical datasheet with complete property values for INEOS Wire & Cable BPD2000E is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
BPD2000E is an unstabilised low density thermoplastic polyethylene. It is designed for use in medium voltage power cable insulation and applications requesting extra cleanliness using the direct peroxide injection (DPI) process.
General  
Material Status 
  • Commercial: Active
Availability 
  • Europe
Features 
  • Low Density
Uses 
  • Medium Voltage Insulation
  • Wire & Cable Applications
  
Agency Ratings 
RoHS Compliance 
Forms 
  • Pellets
Physical
Nominal Value
Unit
Test Method
Density 2
g/cm³
 ISO 1183/D
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ISO 1133
Mechanical
Nominal Value
Unit
Test Method
Tensile Stress (Break)
psi
 IEC 60811-1-1
Tensile Strain (Break)
%
 IEC 60811-1-1
Electrical
Nominal Value
Unit
Test Method
Volume Resistivity (73°F)
ohm·cm
 ASTM D257
Dielectric Strength
V/mil
 ASTM D149
Dielectric Constant (50 Hz)
 
 ASTM D150
Dissipation Factor (50 Hz)
 
 ASTM D150
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: INEOS Wire & Cable BPD2000E, INEOS Wire Cable BPD2000E, INEOS Wire & Cable , INEOS Wire Cable, INEOSWireCableBPD2000E, INEOSWireCable, CableBPD 2000 E, CableBPD2000E, CableBPD2000, Cable, BPD 2000 E, BPD2000E, BPD2000, 2000E, Polyethylene, Low Density, Polyethylene Low Density, LDPE, Polyethylene, PE, Ineos Polyolefins, PolyethyleneLowDensity, 2000BPD, 2000CableBPD
Features
Features may also be described by the following terms: Low Density, Low Specific Gravity.
Uses
Uses may also be described by the following terms: Wire and Cable Applications, Wire & Cable Applications, Medium Voltage Insulation.
Agency Ratings
This plastic material has 5 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): ASTM (1), ISO (1), AEIC (1), EDF (1), IEC (1).
Extrusion
Nominal Value
Unit
 
Melt Temperature
°F
  
Notes
1Typical properties: these are not to be construed as specifications.
2Conditioned according to ISO 1872/1
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.