IDES Prospector Already have an account? Login Here

IDES

Dow Corning® 236

Silicone

Supplied by Dow Corning Corporation

The technical datasheet with complete property values for Dow Corning® 236 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Features 
  • Electrically Insulating
  • Good Chemical Resistance
  • Good Corrosion Resistance
  • Good Toughness
  • Good Weather Resistance
  • Low to No Water Absorption
Uses 
  • Coating Applications
  • Insulation
  
Appearance 
  • White
Forms 
  • Liquid
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Apparent Density
g/cm³
 ASTM D1895
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength (Yield)
psi
 ASTM D638
Tensile Elongation (Yield)
%
 ASTM D638
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore A)
 
 ASTM D2240
Thermoset
Nominal Value
Unit
Test Method
Shelf Life
wk
  
Thermoset Mix Viscosity (77°F)
cP
 ASTM D2393
Demold Time (77°F)
min
  
Additional Information
Continuous Use Temperature Range: -70 to 350°F
Maximum Intermittent Use Temperature: 400°F
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Dow Corning® 236, Dow Corning 236, Dow Corning® , Dow Corning, DowCorning236, DowCorning, 236, Silicone
Features
Features may also be described by the following terms: Good Chemical Resistance, Chemical Resistant, Good Corrosion Resistance, Corrosion Resistant, Good Toughness, Tough, Low Water Absorption, Low Moisture Absorption, Water Resistant, Moisure Resistant, Good Weather Resistance, Weather Resistant.
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.