IDES Prospector Already have an account? Login Here

IDES

Dow Corning® 3-6548

Silicone

Supplied by Dow Corning Corporation

The technical datasheet with complete property values for Dow Corning® 3-6548 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Features 
  • Flame Retardant
  • Good Thermal Stability
  • Thermally Insulating
Uses 
  • Foam
  • Insulation
  • Sealants
  • Seals
  
Appearance 
  • Black
Forms 
  • Liquid
Physical
Nominal Value
Unit
Test Method
Apparent Density
g/cm³
 ASTM D1895
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength (Yield)
psi
 ASTM D638
Thermal
Nominal Value
Unit
Test Method
Thermal Conductivity
Btu·in/hr/ft²/°F
 ASTM C177
Electrical
Nominal Value
Unit
Test Method
Volume Resistivity
ohm·cm
 ASTM D257
Dielectric Strength
V/mil
 ASTM D149
Dissipation Factor (100 kHz)
 
 ASTM D150
Thermoset
Nominal Value
Unit
Test Method
Shelf Life
wk
  
Thermoset Mix Viscosity (77°F)
cP
 ASTM D2393
Demold Time (73°F)
min
  
Additional Information
Useful Temperature Range: -70.6 to 500°F
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Dow Corning® 3-6548, Dow Corning 36548, Dow Corning® , Dow Corning, DowCorning36548, DowCorning, 3-6548, 36548, 3:6548, 3/6548, 3+6548, 3_6548, 3 6548, Silicone, 65483
Features
Features may also be described by the following terms: Good Thermal Stability.
Uses
Uses may also be described by the following terms: Sanitary Products.
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.