IDES Prospector Already have an account? Login Here

IDES

AT 214

Low Density Polyethylene

Supplied by Celanese EVA Performance Polymers

The technical datasheet with complete property values for AT 214 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
This resin is suitable for the production of extruded, non-crosslinked and crosslinked foamed good.
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Features 
  • Crosslinkable
  • Foamable
  
Uses 
  • Foam
Agency Ratings 
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ASTM D1505
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ASTM D1238
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength 2 (Break)
psi
 ASTM D638
Tensile Elongation 3 (Break)
%
 ASTM D638
Thermal
Nominal Value
Unit
Test Method
Brittleness Temperature
°F
 ASTM D746
Vicat Softening Temperature
°F
 ASTM D1525
Melting Temperature
°F
 ASTM D3418
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: AT 214, AT , AT214, 214, Polyethylene, Low Density, Polyethylene Low Density, LDPE, Polyethylene, PE, Celanese EVA, PolyethyleneLowDensity
Agency Ratings
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1).
Notes
1Typical properties: these are not to be construed as specifications.
22.0 in/min
320 in/min
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.