IDES Prospector Already have an account? Login Here

IDES

Honam LLDPE UR654

Linear Low Density Polyethylene

Supplied by Honam Petrochemical Corporation

The technical datasheet with complete property values for Honam LLDPE UR654 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
Features 
  • Good Moldability
  • Good Weather Resistance
  
Uses 
  • Tanks
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ASTM D1505
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ASTM D1238
Environmental Stress-Cracking Resistance (F50)
hr
 ASTM D1693
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength
     ASTM D638
Yield
psi
  
Break
psi
  
Tensile Elongation (Break)
%
 ASTM D638
Flexural Modulus
psi
 ASTM D790
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact (73°F)
ft·lb/in
 ASTM D256
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore D)
 
 ASTM D2240
Thermal
Nominal Value
Unit
Test Method
Vicat Softening Temperature
°F
 ASTM D1525
Melting Temperature
°F
 Internal Method
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Honam LLDPE UR654, Honam LLDPE , HonamLLDPEUR654, HonamLLDPE, LLDPEUR 654, LLDPEUR654, LLDPE, UR 654, UR654, Polyethylene, Linear Low Density, Polyethylene Linear Low Density, Polyethylene, PE, Honam Petrochem, PolyethyleneLinearLowDensity, 654UR, 654LLDPEUR
Features
Features may also be described by the following terms: Good Moldability, Good Weather Resistance, Weather Resistant.
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.