IDES Prospector Already have an account? Login Here

IDES

Seculene® PPR 1240 TV20 S0

Polypropylene

Talc Filler

Supplied by BSB Recycling GmbH

The technical datasheet with complete property values for Seculene® PPR 1240 TV20 S0 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Europe
Filler / Reinforcement 
  • Talc Filler
Recycled Content 
  • Yes
Uses 
  • Automotive Applications
Agency Ratings 
 
Automotive Specifications 
Forms 
  • Pellets, Reprocessed
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ISO 1183
Melt Volume-Flow Rate (MVR) (230°C/2.16 kg)
in³/10min
 ISO 1133
Molding Shrinkage
%
 DIN 53464
Ash Content
%
  
Mechanical
Nominal Value
Unit
Test Method
Tensile Stress
     ISO 527-2
Yield
psi
  
Break
psi
  
Tensile Strain (Break)
%
 ISO 527-2
Flexural Modulus
psi
 ISO 178
Impact
Nominal Value
Unit
Test Method
Charpy Notched Impact Strength (73°F)
ft·lb/in²
 ISO 179/eA
Hardness
Nominal Value
Unit
Test Method
Shore Hardness (Shore D)
 
 ISO 868
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Seculene® PPR 1240 TV20 S0, Seculene PPR 1240 TV20 S0, Seculene® , Seculene, SeculenePPR1240TV20S0, PPR 1240 TV 20 S 0, PPR 1240 TV20 S0, PPR1240, 1240TV, TV20, 20S, S0, PPR1240TV20S0, Polypropylene, Unspecified, Polypropylene Unspecified, PP, Unspecified, PP Unspecified, Polypropylene, PP, BSB Recycling, PolypropyleneUnspecified, PPUnspecified, 1240PPR
Generic Name
Generic Name may also be described by the following terms: Polypropilene, Polypropelene.
Uses
Uses may also be described by the following terms: Automotive Applications, Automotive Sector.
Automotive Specifications
This plastic material has approval for 1 automotive specifications from the following agencies (the number in parentheses shows the number of specifications for that agency): GM (1).
Agency Ratings
This plastic material has 2 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): ISO/TS (1), ISO (1).
Injection
Nominal Value
Unit
 
Drying Temperature
°F
  
Drying Time
hr
  
Processing (Melt) Temp
°F
  
Mold Temperature
°F
  
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.