IDES Prospector Already have an account? Login Here

IDES

Hostaform® C 27021 TF

Acetal (POM) Copolymer

Supplied by Ticona

The technical datasheet with complete property values for Hostaform® C 27021 TF is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
Hostaform® C 27021 TF is an injection molding type, modified with PTFE good
chemical resistance to solvents, fuel and strong alkalis as well as
good hydrolysis resistance high resistance to thermal and oxidative
degradation for sliding combinations with very low coefficient of
friction. High viscosity
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Additive 
  • PTFE Lubricant
Features 
  • Alkali Resistant
  • Fuel Resistant
  • Good Chemical Resistance
  • High Viscosity
  • Hydrolysis Resistant
  • Low Friction
  • Lubricated
  • Oxidation Resistant
  • Solvent Resistant
RoHS Compliance 
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ISO 1183
Melt Volume-Flow Rate (MVR) (190°C/2.16 kg)
in³/10min
 ISO 1133
Mechanical
Nominal Value
Unit
Test Method
Tensile Modulus
psi
 ISO 527-2/1A/1
Tensile Stress (Yield)
psi
 ISO 527-2/1A/50
Tensile Strain (Yield)
%
 ISO 527-2/1A/50
Nominal Tensile Strain at Break
%
 ISO 527-2/1A/50
Flexural Modulus (73°F)
psi
 ISO 178
Impact
Nominal Value
Unit
Test Method
Charpy Notched Impact Strength (73°F)
ft·lb/in²
 ISO 179/1eA
Charpy Unnotched Impact Strength (73°F)
ft·lb/in²
 ISO 179/1eU
Thermal
Nominal Value
Unit
Test Method
Melting Temperature 2
°F
 ISO 11357-3
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Hostaform® C 27021 TF, Hostaform C 27021 TF, Hostaform® , Hostaform, HostaformC27021TF, C 27021 TF, C27021, 27021TF, C27021TF, Acetal Copolymer, Acetal Copolymer, Acetal (POM) Copolymer, Acetal POM Copolymer, Acetal, pom, Ticona, AcetalPOMCopolymer, 27021C
Features
Features may also be described by the following terms: Low Friction, High Viscosity, Good Chemical Resistance, Chemical Resistant.
Injection
Nominal Value
Unit
 
Processing (Melt) Temp
°F
  
Mold Temperature
°F
  
Screw L/D Ratio
 
  
Injection Notes
Standard injection moulding machines with three phase (15 to 25 D)
plasticating screws will fit.
Notes
1Typical properties: these are not to be construed as specifications.
210°C/min
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.