IDES Prospector Already have an account? Login Here

IDES

PELPRENE™ P80C

Thermoplastic Polyester Elastomer

Supplied by TOYOBO America, Inc.

The technical datasheet with complete property values for PELPRENE™ P80C is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Features 
  • Good Flexibility
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Melt Mass-Flow Rate (MFR) (230°C/2.16 kg)
g/10 min
 ASTM D1238
Molding Shrinkage - Flow (0.0787 in)
in/in
 ASTM D955
Water Absorption (Equilibrium, 73°F, 65% RH)
%
 ASTM D570
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength
     ASTM D638
--
psi
  
50% Strain
psi
  
Tensile Elongation (Break)
%
 ASTM D638
Flexural Modulus
psi
 ASTM D790
Compressive Strength (10% Strain)
psi
 ASTM D695
Taber Abrasion Resistance (1000 Cycles)
mg
 ASTM D1044
Elastomers
Nominal Value
Unit
Test Method
Tear Strength
lbf/in
 ASTM D624
Compression Set
%
 JIS K6301
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact
 
 ASTM D256
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness
      
Shore A
 
 JIS K6301
Shore D
 
 ASTM D2240
Thermal
Nominal Value
Unit
Test Method
Deflection Temperature Under Load (264 psi, Unannealed)
°F
 ASTM D648
Brittleness Temperature
°F
 JIS K6301
Vicat Softening Temperature
°F
 ASTM D1525
Melting Temperature
°F
 DSC
CLTE - Flow
in/in/°F
 ASTM E831
Electrical
Nominal Value
Unit
Test Method
Volume Resistivity
ohm·cm
 ASTM D257
Dielectric Strength
V/mil
 JIS K2111
Flammability
Nominal Value
Unit
Test Method
Flame Rating - UL
 
 UL 94
Additional Information
Nominal Value
Unit
Test Method
Resilience
%
 JIS K6301
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: PELPRENE™ P80C, PELPRENE P80C, PELPRENE™ , PELPRENE, PELPRENEP80C, P 80 C, P80C, P80, 80C, Thermoplastic Polyester Elastomer, TPEE, Thermoplastic Elastomer, TPE, Toyobo, ThermoplasticPolyesterElastomer, ThermoplasticElastomer, 80P
Features
Features may also be described by the following terms: Good Flexibility, Flexible.
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.