IDES Prospector Already have an account? Login Here

IDES

Kingfa APO-2004

Polypropylene

Supplied by Kingfa

The technical datasheet with complete property values for Kingfa APO-2004 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
Uses 
  • Automotive Applications
Automotive Specifications 
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ISO 1183
Melt Mass-Flow Rate (MFR) (230°C/2.16 kg)
g/10 min
 ISO 1133
Molding Shrinkage (73°F)
%
 Internal Method
Ash Content 2 (1472°F)
%
 ISO 3451-1
Mechanical
Nominal Value
Unit
Test Method
Tensile Stress (Break)
psi
 ISO 527-2/50
Tensile Strain (Yield)
%
 ISO 527-2/50
Flexural Modulus 3
psi
 ISO 178
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact Strength (73°F)
ft·lb/in²
 ISO 180
Thermal
Nominal Value
Unit
Test Method
Heat Deflection Temperature
      
66 psi, Unannealed, 0.157 in Span
°F
 ISO 75-2/B
264 psi, Unannealed, 0.157 in Span
°F
 ISO 75-2/A
Flammability
Nominal Value
Unit
Test Method
Burning Rate (0.118 in)
in/min
 ISO 3795
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Kingfa APO-2004, Kingfa APO2004, Kingfa , KingfaAPO2004, APO, APO-2004, APO2004, APO:2004, APO/2004, APO+2004, APO_2004, APO 2004, Polypropylene, Unspecified, Polypropylene Unspecified, PP, Unspecified, PP Unspecified, Polypropylene, PP, PolypropyleneUnspecified, PPUnspecified, 2004APO
Generic Name
Generic Name may also be described by the following terms: Polypropilene, Polypropelene.
Uses
Uses may also be described by the following terms: Automotive Applications, Automotive Sector.
Automotive Specifications
This plastic material has approval for 1 automotive specifications from the following agencies (the number in parentheses shows the number of specifications for that agency): FORD (1).
Injection
Nominal Value
Unit
 
Drying Temperature
°F
  
Drying Time
hr
  
Rear Temperature
°F
  
Middle Temperature
°F
  
Front Temperature
°F
  
Processing (Melt) Temp
°F
  
Mold Temperature
°F
  
Injection Rate
 
  
Back Pressure
psi
  
Injection Notes
Processing Temp. Limit: 260°C
Notes
1Typical properties: these are not to be construed as specifications.
230 min
30.079 in/min
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.