IDES Prospector Already have an account? Login Here

IDES

Badaflex® TPE-S 40A 1462 AB transparent

Styrene Ethylene Butylene Styrene Block Copolymer

Supplied by Bada AG

The technical datasheet with complete property values for Badaflex® TPE-S 40A 1462 AB transparent is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
Transparent, low density Thermoplastic Elastomer for injection moulding based on SEBS Copolymer

Overmoulding capability: Polypropylene (PP)
General  
Material Status 
  • Commercial: Active
Availability 
  • Europe
Features 
  • Low Density
Appearance 
  • Clear/Transparent
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 DIN 53479
Elastomers
Nominal Value
Unit
Test Method
Tensile Stress (Yield)
psi
 DIN 53504
Tensile Elongation (Break)
%
 DIN 53504
Compression Set (73°F, 72.0 hr)
%
 ISO 815
Hardness
Nominal Value
Unit
Test Method
Shore Hardness (Shore A)
 
 DIN 53505
Additional Information
Nominal Value
Unit
Test Method
Tear Strength
lbf/in
 DIN 53515
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Badaflex® TPE-S 40A 1462 AB transparent, Badaflex TPES 40A 1462 AB transparent, Badaflex® , Badaflex, BadaflexTPES40A1462ABtransparent, TPE, TPE S 40 A 1462 AB transparent, TPE-S 40A 1462 AB transparent, TPES 40A 1462 AB transparent, TPE:S 40A 1462 AB transparent, TPE/S 40A 1462 AB transparent, TPE+S 40A 1462 AB transparent, TPE_S 40A 1462 AB transparent, TPE S 40A 1462 AB transparent, TPES, S40, 40A, A1462, 1462AB, ABtransparent, TPES40A1462ABtransparent, TPE_S40A1462ABtransparent, Styrene Ethylene Butylene Styrene Block Copolymer, SEBS, Thermoplastic Elastomer, Bada Euro, StyreneEthyleneButyleneStyreneBlockCopolymer, ThermoplasticElastomer, STPE
Features
Features may also be described by the following terms: Low Density, Low Specific Gravity.
Injection
Nominal Value
Unit
 
Processing (Melt) Temp
°F
  
Mold Temperature
°F
  
Injection Rate
 
  
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.