IDES Prospector Already have an account? Login Here

IDES

Badaflex® TPE-S 60A 1344 LD GR

Styrene Ethylene Butylene Styrene Block Copolymer

Supplied by Bada AG

The technical datasheet with complete property values for Badaflex® TPE-S 60A 1344 LD GR is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
Thermoplastic Elastomer as a low density and low odour injection moulding grade for automotive interieur applications


Overmoulding capability: Polypropylene (PP)
General  
Material Status 
  • Commercial: Active
Availability 
  • Europe
Features 
  • Low Density
  • Low to No Odor
 
Uses 
  • Automotive Interior Parts
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
DIN 53479
Elastomers
Nominal Value
Unit
Test Method
Tensile Stress (Yield)
psi
DIN 53504
Tensile Elongation
    DIN 53504
Across Flow: Break
%
 
Flow: Break
%
 
Compression Set
    DIN 53515
73°F, 72.0 hr
%
 
158°F, 24.0 hr
%
 
Hardness
Nominal Value
Unit
Test Method
Shore Hardness (Shore A)
 
DIN 53505
Additional Information
Nominal Value
Unit
Test Method
Tear Strength
    DIN 53515
-- 2
lbf/in
 
Transverse Direction
lbf/in
 
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Badaflex® TPE-S 60A 1344 LD GR, Badaflex TPES 60A 1344 LD GR, Badaflex® , Badaflex, BadaflexTPES60A1344LDGR, TPE, TPE S 60 A 1344 LD GR, TPE-S 60A 1344 LD GR, TPES 60A 1344 LD GR, TPE:S 60A 1344 LD GR, TPE/S 60A 1344 LD GR, TPE+S 60A 1344 LD GR, TPE_S 60A 1344 LD GR, TPE S 60A 1344 LD GR, TPES, S60, 60A, A1344, 1344LD, LDGR, TPES60A1344LDGR, TPE_S60A1344LDGR, Styrene Ethylene Butylene Styrene Block Copolymer, SEBS, Thermoplastic Elastomer, Bada Euro, StyreneEthyleneButyleneStyreneBlockCopolymer, ThermoplasticElastomer, STPE
Features
Features may also be described by the following terms: Low Density, Low Specific Gravity, Low Odor.
Injection
Nominal Value
Unit
 
Processing (Melt) Temp
°F
 
Mold Temperature
°F
 
Injection Rate
 
 
Notes
1Typical properties: these are not to be construed as specifications.
2Parallel Direction
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.